AEG Rear Camera System RV 3.5 - Manual (Page 22)

Caution! If you are unfamiliar with the
I installation and the connections or are
unsure with one of these steps, please
consult a specialist regarding the installation!
There is a risk of property damage or personal
injuries!
Using the second cable clamp connect the
vehicle‘s 12 V - (negative) reversing light cable
with the black transmitter cable as shown in
images 8 - 11. Then reconnect the negative cable
to the vehicle‘s battery.
Close the cable clamp
fuse cover.
Using a pair of pliers
(not included) push the
protruding metal contact
into the cable clamp .
This will connect the two
cables.
Place the red transmitter
cable sideways into the
clamp connector (see
image 9).
Place the 12 V +
(positive) reversing light
cable sideways into the
clamp connector (see
image 8).
Using the two cable clamps connect the cables
to the reversing light and follow the following
steps for connecting the respective cables. 7
7
7
7
7
7
Image 11
Image 10
Image 9
Image 8
Transmitter
Earth
Black
12 V supply cable
Image 7
Camera cable
Camera
Reversing
light
Cable
clamp
Red
+ 12 V DC reversing light
Step 7: Connecting the transmitter supply
cable
Remove the cover of the reversing light. Remove
the bulb holder from the reversing light housing.
Find the vehicle supply cables to the reversing
light. Please refer to the automaker‘s manual.
Caution! Disconnect the negative cable from the
vehicle‘s battery before working on the vehicle‘s
electric circuit! Stored information, codes and pro-
gramming may be lost!
Now connect the vehicle‘s 12 V + (positive)
power supply to the reversing light to the red
transmitter cable. Then connect the vehicle‘s
12 V - (negative) earth cable for the reversing
light with the black transmitter cable (see
image 7).
22
97152_R ckfahrkamera_RV3.5_ Manual _07_03_12_Print
Mittwoch, 7. M rz 2012 11:42:17