0 product description – AEG Battery Charger LP 10.0 User Manual

Page 23

Advertising
background image

23

Illustration may slightly differ from product.
Subject to change for the purpose of technical
advances. Decorations not included.

After unpacking immediately check all parts
are included and inspect all parts for damage!

Do not use the charger if damaged or if the
operator

'

s manual is missing!

1 Charger LP 10.0
1 Operator

'

s Manual

3.1 Contents

3.0 PRODUCT
DESCRIPTION

2.4.7 The charging time for the respective
battery / storage battery depends on the
capacity.

2.4.6 Clean battery terminals before charging!

Caution

- risk of electrical shock!

2.4.5 Before charging inspect the
battery for damage! Never charge
defective batteries! On lead acid
batteries with vent caps always first
check the level of battery fluids. If the
fluid level is low, add distilled water to
the battery cells up to the level
recommended by the battery

manufacturer.

Attention

- always wear

protective clothing!

2.4.4 Follow the battery manufacturer

'

s

operating and safety instructions!

2.4.3 If the battery must be removed from the
vehicle for charging, be sure the ignition and
any loads in the vehicle are powered off! First
remove the negative terminal (black cable) from
the battery. Follow the operator

'

s manual and the

vehicle manufacturer

'

s safety instructions!

2.4.2 Avoid any contact with caustic
battery acid! If your body comes into
direct contact with battery acid,

immediately thoroughly flush the affected area
with water and seek medical advice! In the event
battery acid comes into contact with the eyes,
immediately flush with running clear water for
several minutes. In this case also seek immediate
medical attention or a hospital emergency room!

2.4.1 Always wear protective eyewear, protective
gloves and closed clothing to cover the entire
body when handling lead storage batteries!

2.4 Storage battery / battery safety
notices

2.3.14 Never add fluids to the battery during
charging!

2.3.13 When not in use always unplug the
device from the 230 V alternating current mains
source!

2.3.12 In the event of malfunction and damage to
the charger or battery during operation,
immediately disconnect the equipment from the
230 V alternating current mains source!

GB

0

5

25

75

95

100

97100_Ladeger

t _LP_10.0 Manual _09_12_2011_print

Freitag, 9. Dezember 2011 11:11:28

Advertising