Aga Ranges AFHR-36 - Manual (Page 14)

Use & Care Guide
14
• Certain sounds may accompany the various cycles of
the ice maker. The motor may have a slight hum, the
cubes will rattle as they fall into an empty storage pan and
the water valve may click or “buzz” occasionally.
• If the ice is not used frequently, the ice cubes will
become cloudy, shrink, stick together and taste stale.
Empty the ice storage bin periodically
and wash it in lukewarm water. Be
sure to dry the bin thoroughly before
replacing it .
• Beverages and foods should not
be placed in the ice storage bin for
quick chilling. These items can block
the sensor arm, causing the ice maker to malfunction.
• Turn off (arm up) the ice maker when the water sup-
ply is to be shut off for several hours.
To Remove the Ice Bin:
• Pull it forward, away from the ice maker. To avoid the
ice maker dumping ice while the bin is removed, turn the
ice maker off by raising the sensor arm.
To Install the Ice Bin:
• Reverse the above procedure. Turn the ice maker on
by lowering the sensor arm.
To avoid personal injury or property damage,
observe the following:
• Do not place fingers or hands on the
automatic ice making mechanism while the
refrigerator is plugged in. This will help pro
tect you from possible injury. It will also pre
vent interference with moving parts of the
ejector mechanism and the heating element
that releases the cubes.
• Under certain rare circumstances, ice cubes
may be discolored, usually appearing with a
green-bluish hue. The cause of this unusual
discoloration can be a combination of factors
such as certain characteristics of local waters,
household plumbing and the accumulation of
copper salts in an inactive water supply line
which feeds the ice maker. Continued
consumption of such discolored ice cubes
may be injurious to health. If such
discoloration is observed, discard the ice
cubes and contact your dealer to purchase
and install a water line filter.
• Water damage due to improper water
connection may cause mold/mildew growth.
• Clean up water and ice spills to avoid person
al injury and to prevent mold/mildew growth.
Ice and Water
Water Dispenser
The Water Dispenser is located on the left side wall of
the fresh food section. This design is
for cold water dispensing only.
To Dispense Water:
•
Hold container under spout and
press dispenser pad.