Aga Ranges AFHR-36 - Manual (Page 20)

Use & Care Guide
20
Care and Cleaning
To avoid electrical shock which can cause
severe personal injury or death, discon
nect power to refrigerator before clean
ing. After cleaning, reconnect power.
Cleaning the Outside
Circuit breakers must be shut off before
cleaning. Using a damp cloth and mild dish-
washing detergent, wipe surface lightly. Dry and
polish with a clean, soft cloth. Do not wipe panel
with a soiled dishcloth or wet towel, these may
leave residue that can erode the paint. Do not
use scouring pads, powdered cleaners, or
bleach because these products can scratch,
and/or weaken the paint. Wring excess water
from sponge or cloth to avoid excess moisture,
especially when cleaning in vicinity of switches,
lights or controls.
Removing Odors From
Refrigerator
1. Remove all food and turn the refrigerator
OFF.
2. Disconnect power to the refrigerator.
3. Clean the walls, floor, ceiling of cabinet inte-
rior, drawers, shelves and gaskets according to
the instructions on page 20 and 21.
• Clean condenser coils as indicated in the
cleaning instructions every three months. This
will increase energy efficiency and cooling per-
formance.
Replacing Light Bulbs
To avoid electrical shock which can
cause severe personal injury or death,
disconnect power to refrigerator before
replacing light bulb. After replacing light
bulb, reconnect power.
To avoid personal injury or property dam
age, observe the following:
• Allow light bulb to cool.
• Wear gloves when replacing light bulb.
Fresh Food Section
(style of light shield varies)
1. Slide clear light shield toward back of com
partment to release from light assembly.
2. Remove light bulbs.
3. Replace with appliance bulbs no greater
than 40 watts.
4. Replace light bulb cover by inserting tabs on
light shield into liner holes on each side of
light assembly. Slide shield toward front of
refrigerator until it locks into place. Do not
force shield beyond locking point. Doing so
may damage light shield.