Aga Ranges AFHR-36 - Manual (Page 6)

Use & Care Guide
6
To protect property and refrigerator from dam-
age, observe the following:
•
Protect vinyl or other flooring with card-
board, rugs, or other protective material.
•
Do not use power tools when perform-
ing levelling procedure
To enhance the appearance and maintain per-
formance, the refrigerator should be level.
Materials Needed
•
3/8” hex head driver.
• Carpenter’s level.
Slide unit into opening, remove toe grill and
bracket covers.
Once unit is in place, adjust both front stabiliz-
ing legs (B) securely against floor.
1. Remove toe grille:
• Grasp firmly and pull
outward to unclip.
2. Remove bottom bracket cover(s).
• Place the eraser end of a pencil or simi-
lar blunt tool in the cover notch.
• Use slight pressure to pry the cover
loose.
•
Continue to maintain
downward pressure to the
notched side of the cover
while swinging it off.
3. Using hex head driver, turn the front adjust-
ment screws (A) on each side clockwise to raise or
counter-clockwise to lower the front of the refrigera-
tor. (ensure the back of the unit is firmly under the
anti-tip bracket.)
4.
There are rear adjustment screws (B). Using
the hex head driver, turn each of these adjustment
screws
(B) to raise or lower the rear of the refrigerator.
(ensure the back of the unit is firmly under the anti-
tip bracket.)
5.
Using the carpenter’s level, make sure front
of refrigerator is 1/4" (6 mm) or 1/2 bubble higher
than back of refrigerator and that the refrigerator is
level from side to side.
6.
Turn stabilizing legs (C) clockwise until firmly
against floor.
7.
Turn adjustment screws (A) counter clock
wise to allow the full weight of the refrigerator to rest
on the stabilizing legs.
8. Replace bracket cover(s):
• Position cover into the outer edge of the
hinge.
• Swing the cover toward the cabinet and snap
it into place.
9. Replace the toe grill.
Note:
•
For proper reinstallation, ensure the “top”
marking on the interior of the toe grill is oriented cor-
rectly.
•
Align the toe grill mounting clips with the
lower cabinet slots.
•
Push the toe grill firmly until it snaps into
place.
Leveling