Aga Ranges AFHR-36 - Manual (Page 8)

Use & Care Guide
8
• Set the freezer control on 4.
• Set the refrigerator control on 4.
• Let the refrigerator run at least 8 to 12 hours before
adding food.
Warm Cabinet Surfaces
At times, the front of the refrigerator cabinet may be
warm to the touch. This is a normal occurrence that
helps prevent moisture from condensing on the cabinet.
This condition will be more noticeable when you first
start the refrigerator, during hot weather and after exces-
sive or lengthy door openings.
Adjusting the Controls
• 24 hours after adding food, you may decide that one
or both compartments should be colder or warmer. If so,
adjust the control(s) as indicated in the Temperature
Control Guide table below. See page 17 for instructions
on checking compartment temperature.
• Except when starting the refrigerator, do not change
either control more than one number at a time.
• Allow 24 hours for temperatures to stabilize .
Temperature Control Guide
2. Remove plastic cap from water valve inlet
port.
3. Place brass nut (A) and sleeve (B) on copper
tube end as illustrated. Reminder: Do not use
an old sleeve.
4. Place end of copper tubing into water valve
inlet port. Shape tubing slightly. Do not kink –
so that tubing feeds straight into inlet port.
5. Slide brass nut over sleeve and screw nut
into inlet port. Tighten nut with wrench.
IMPORTANT: Do not overtighten. Cross
threading may occur.
6. Pull on tubing to confirm connection is secure. Connect
tubing to frame with water tubing clamp (C) and turn on
water supply. Check for leaks and correct if necessary.
Continue to observe the water supply connection for two to
three hours prior to moving the refrigerator to its permanent
location.
7. Monitor water connection for 24 hours. Correct leaks, if
necessary.
Touch Temperature Controls
The controls are located at the top front of the refrigerator
compartment.
Control
Initial Control Settings
After plugging the refrigerator in, set the controls as follows:
• Pressing the or pads adjusts the controls to
the desired setting.
• The temperature control range for both compartments is
1 through 7 (coldest).
Turn refrigerator OFF
Set the refrigerator control
to next higher number by
pressing the pad.
Set the refrigerator control
to next lower number by
pressing the pad.
Set the freezer control to
next higher number by
pressing the pad.
Set the freezer to next
lower number by pressing
the pad.
Press the refrigerator or
freezer pad until a
dash (-) appears on the dis-
play.
Refrigerator too warm
Refrigerator too cold
Freezer too warm
Freezer to cold