Bushnell WEATHERFX 960900C - Manual (Page 6)

6
STEP 4: SETTING UP THE RECEIVER UNIT
The Receiver may be powered by batteries or from the included AC
adapter. To use the AC adapter, insert the round plug into the jack
on the lower left side of the unit, then connect it to a wall outlet. To
install batteries, slide the battery door down in the direction of the
arrow to remove it, and insert four AA batteries (alkaline or lithium) in
the indicated direction. Replace the battery door. Insert the included
easel stand into the key slot (above the battery door) on the back of
the Receiver unit, then rotate it (clockwise) into place so the stand
will prop up the Receiver unit and allow it to stand upright. Note: as
soon as batteries are installed or the AC adapter is connected, the unit
will power on, and run through a display test routine, cycling through the
various backlight colors, then displaying letters and numbers in various
sections of the display-this is normal, and takes less than a minute. When
completed, the display will show a “Searching for PC” message (press
SEARCH on the back of the Receiver if it does not). Keep the Receiver
near the PC until the setup is complete-then you may move it anywhere
in your home, up to about 245 ft (75m) from the Transmitter.
STEP 5: TRANSMIT DATA FROM PC SOFTWARE TO THE RECEIVER
This is a simple process, in fact it’s normally completely automatic after
the initial setup. First, make sure the Receiver displays the “Searching
for PC” message. If it isn’t, press the SEARCH button on the back of
the Receiver-you should then see the “Searching...” message, and the
Signal strength icon ( )on the top left corner of the display should
be blinking. All you need to do now is click “Send To Receiver” on
the Weather FXi software screen (Fig. 7) (make sure the first or “home”
location box is selected), and within a few seconds, the data on the
Receiver display will be synchronized to the data currently seen on
the PC. The LED light on the USB Transmitter will glow red when you
click “Send To Receiver”, then blink while the data is being transmitted
(if this does not happen, the Transmitter is not getting power via USB-
Fig. 5 Fig. 6
INSTALLATION and SETUP INSTRUCTIONS