Olympus DS-2500 - Manual (Page 14)

Power supply
Charging by connecting to a computer via
USB
You can charge the batteries by connecting to a
PC’s USB port. When charging, be sure to correctly
place the rechargeable batteries (supplied) into the
recorder (
☞ P.12).
1
Boot the PC.
2
Connect the USB cable to the USB port
of the PC.
Do not charge primary batteries such as alkaline
or lithium batteries. It may cause battery
leakage or heating, which may cause the
recorder to malfunction.
3
While the recorder is in stop mode or
turned off, connect the USB cable to the
connecting terminal on the bottom of
the recorder.
4
Press the PLAY/OK button to start
charging.
• While [Press OK to start charging] is flashing, press
the PLAY/OK button.
5
Charging is completed when battery
indication becomes to [
¿].
Charging time: approximately 3 hours *
* It shows the approximate time when
charging rechargeable batteries fully from no
remaining power at the room temperature.
The charging time will be changed depending
on the remaining amount and the state of
batteries.
Before connecting the USB cable, exit HOLD
mode (
☞ P.18).
Press OK to
start charging
Remote
(Storage)
Battery Full
Remote
(Storage)
Notes
• The recorder cannot be charged when the PC is
not turned on. It may not also be charged when
the PC is in standby, hibernate, or sleep mode.
• Do not charge the recorder with the USB hub
connected.
1
EN
14
Po
we
r s
u
p
p
ly