Belkin F1UP002 - Manual (Page 56)

56
Wireless Function: You can select to enable or disable the wireless
function manually. If you manually enable wireless function, the Print
Server’s wireless LAN will be always enabled and Ethernet will be
always disabled. If you manually disable the wireless function, the
Print Server’s wireless LAN will be always disabled and Ethernet will
be always enabled. You can also select “Auto” to let the Print Server
automatically decide to enable or disable the wireless function. The
Print Server only can work in either Ethernet or wireless-LAN mode.
It cannot work in both Ethernet and wireless-LAN mode at the same
time. When the Print Server starts up, it will automatically detect if
the LAN port is connected to an active network by an Ethernet cable.
If the Print Server is connected to an active network by Ethernet
cable when starting up, the Print Server will run in Ethernet mode. If
the Print Server is not connected to an active network by Ethernet
cable when starting up, the Print Server will run in wireless-LAN
mode. The Print Server’s default is in “Auto” mode.
Domain Country:
The wireless channels are different from country
to country. Generally, the channels are from 1 to 11 in the USA and
from 1 to 13 in Europe. The operating channel will be set to the Print
Server before importing. If you are in a different country, make sure
that you have set the available channels according to your location
Wireless Configuration
If you want to use the Print Server through a wireless LAN, set it
up through Ethernet first and make sure your wireless-LAN setting
is correct. After setting up the wireless LAN, unplug the Ethernet
cable and restart the Print Server. You can start to use the Print
Server through a wireless LAN. If the wireless configuration does
not work, plug in the Ethernet cable again, restart the Print Server,
and configure it through Ethernet until the wireless-LAN settings are
correct.
Print Server Manager
1
2
3
4
5
6
7
8
9
10
11
se
ct
io
n