Pioneer PDP-428XD - Manual (Page 67)

Using with other equipment 12
67
En
English
P–:
Displays the previous image in the normal or full screen.
P+:
Displays the next image in the normal or full screen.
RED:
Displays the image using the full screen. To quit the full-screen
display, press
RETURN.
GREEN:
Rotates the displayed image clockwise. Each press rotates the
image in the sequence: 90°, 180°, and then 270°.
HOME MENU:
Quits the Home Gallery function.
Note
• Be careful not to display the same image for an extended period
of time. This may cause screen burning/image retention.
• Images smaller than 1024 x 768 pixels are displayed with blank
surrounding.
Starting the Slide Show Setup screen
When the thumbnail screen is displayed, press GREEN to start the
screen for setting up for Slide Show that sequentially changes
images.
1 Select “Display Mode” ( /).
2 Select “Normal” or “Full” ( /).
• With “Full” selected, images are displayed using the full screen.
3 Select “Playback Order” ( /).
4 Select “Name Order” or “Random” ( /).
5 Select “Repeat Mode” ( /).
6 Select “Single Time” or “Loop” ( /).
• With “Loop” selected, Slide Show is repeated until RETURN is
pressed.
7 Select “Playback Mode” ( /).
8 Select “Auto” or “Manual” ( /).
• With “Auto” selected, images automatically change at the
specified intervals.
• With “Manual” selected, images change each time you press
P+/P–.
9 If you have selected “Auto” in step 8, press / to select
“Interval(sec.)”, and then press / to select the desired display
duration for individual images.
• You can select from among 3 seconds, 5 seconds, 10 seconds,
20 seconds, 30 seconds, 60 seconds, and 90 seconds.
10 To start the Slide Show screen, press RETURN to display the
thumbnail screen and then press RED.
• To quit the Home Gallery function, press HOME MENU.
Starting the Slide Show screen
After setting up for Slide Show, you can start Slide Show to
sequentially change images.
1 To start the Slide Show screen, press RED when a thumbnail
screen is displayed.
• With “Auto” selected for “Playback Mode”, images are
automatically changed at the specified intervals.
• With “Manual” selected for “Playback Mode”, press P+/P– to
change images.
• While images are automatically changing, you can stop and
hold automatic image change for approximately 90 seconds by
pressing
RED. To resume, press RED again.
2 When quitting the Slide Show screen, press RETURN to restore
the thumbnail screen or HOME MENU to quit the Home Gallery
function.
Note
• When paused during a slideshow is played, the screen is
automatically changed to the next image in five minutes.
• If no operation is continued for five minutes, the Home Gallery
function automatically finishes except when the slideshow is
played with “Loop” selected for the “Repeat Mode”.
Adjusting the picture quality
When a thumbnail screen is displayed, press YELLOW. The same
picture adjustment screen as the PC source is displayed. For the
subsequent procedure, see page 30.
Home Gallery
HOME MENU Exit
Display Mode
Slide Show Setup
Playback Order Name Order
Repeat Mode Single time
Playback Mode Auto
Interval (sec) 3
Normal
PDP-508XD.book Page 67 Thursday, April 26, 2007 2:34 PM