Pioneer XW-NAC3-R - Manual (Page 18)

Bluetooth ® AUDIO for Wireless Enjoyment of Music 04
18
En
‘Device Disconnected’ is displayed when
Bluetooth wireless technology device is not
connected. In this case, perform the
connection operation from the side of the
Bluetooth wireless technology device.
Listening to Music Contents of
Bluetooth wireless technology
device with Your System
1 Press BT A to switch to Bluetooth AUDIO
input mode.
‘Device Disconnected’ is displayed.
2 Connect the Bluetooth wireless
technology device to the Bluetooth AUDIO.
3 Start playback of music contents stored in
Bluetooth wireless technology device.
The following operations are now possible for
Bluetooth wireless technology devices, using
the remote control. 1
When no Bluetooth wireless technology device
is connected and this unit is not operated for
30 minutes or more after the Bluetooth AUDIO
function is selected, power will automatically
turn OFF.
Radio wave caution
This unit uses a 2.4 GHz radio wave frequency,
which is a band used by other wireless systems
(see list below). To prevent noise or interrupted
communication, do not use this unit nearby
such devices, or make sure these devices are
switched off during use.
• Cordless phones
• Cordless facsimiles
• Microwave ovens
• Wireless LAN devices (IEEE802.11b/g)
• Wireless AV equipment
• Wireless controllers for game systems
• Microwave-based health aids
• Some baby monitors
Other, less common, equipment that may
operate on the same frequency:
• Anti-theft systems
• Amateur radio stations (HAM)
• Warehouse logistic management systems
• Discrimination systems for train or
emergency vehicles
Note
• In the event noise appears in your
television image, there is the possibility
that a Bluetooth wireless technology
enabled device or this unit (including
products supported by this unit) are
causing signal interference with the
antenna input connector of your television,
video, BS tuner, CS tuner, etc.
In this event, increase the distance
between the antenna input connector and
the Bluetooth wireless technology enabled
device or this unit (including products
supported by this unit).
Button What it does
/ Starts normal playback and pauses/
unpauses playback.
 Stops playback.
 Press to skip to the start of the
current file, then previous files. Press
and hold to start fast reverse
scanning.
 Press to skip to the next file. Press
and hold to start fast forward
scanning.
VOLUME
+/– Use to set the listening volume.
Note
1 • Bluetooth wireless technology device should be compatible with AVRCP profile.
• Depending on Bluetooth wireless technology device you use, operation may differ from what is shown in this table.
XW-NAC3_SYXJ.book 18 ページ ２０１０年３月２５日 木曜日 午後７時２１分