Pioneer DVR-3100-S - Manual (Page 30)

Getting started 04
30
En
1 Press STANDBY/ON to switch on.
Also turn on your TV and make sure that it is set to the
correct video input.
2 Press OPEN/CLOSE to open the disc tray.
3 Load a disc.
Load a disc with the label side facing up, using the disc
tray guide to align the disc (if you’re loading a double-
sided DVD-Video disc, load it with the side you want to
play face down).
• If you want to play a DTS audio CD, please first read
the note on page 31.
4 Press PLAY to start playback.
• If you’re playing a DVD-Video or Video CD, a disc
menu may appear when you start playback. Use the
/ / / (cursor) buttons and ENTER to navigate
DVD disc menus, and the number buttons and
ENTER for Video CD menus.
• See the following sections for more details on playing
specific kinds of discs.
5 To stop playback, press STOP.
6 When you’ve finished using the recorder, eject
the disc and switch the recorder back into standby.
• To open/close the disc tray, press OPEN/CLOSE .
Remove the disc before putting the recorder into
standby.
• Press STANDBY/ON to switch the recorder into
standby.
Playing DVD discs
The table below shows the basic playback controls for
DVD-Video, and recordable DVD discs.
STANDBY/ON OPEN/CLOSE
STOP
PLAY
Press to start playback.
If
RESUME is displayed on-screen, play-
back starts from the place last stopped.
Press to stop playback.
You can resume playback from the same
point by pressing
PLAY . (Press STOP
again to cancel the resume function.)
Pauses playback, or restarts playback
when paused.
Press to start scanning. Press repeatedly
to increase the scanning speed. (There are
four scan speeds; the current scan speed
is shown on-screen.)
Press to skip to previous/next chapter/title.
Except VR mode: During playback, enter a
chapter number then press ENTER to skip
directly to that chapter within the currently
playing title.
On some discs, you can also use the num-
ber buttons to select numbered items in
the disc menu.
VR mode only: During playback, enter a
title number then press ENTER .
(Commercial skip) Each press skips for-
ward 30 seconds. Use to a maximum of 4
mins.
During playback, press to start slow-
motion playback. Press repeatedly to
change the playback speed.
While paused, press to advance a single
frame in either direction.
Press to display the ‘top’ menu or menu of
a DVD-Video disc (these are often the
same).
Use the cursor buttons to navigate DVD-
Video disc menus; press
ENTER to select
items.
Press to return to the previous level of a
DVD-Video disc menu.
PLAY
STOP
PAUSE
REV SCAN FWD SCAN
PREV NEXT
CLEAR
CM SKIP
STEP/SLOW
TOP MENU MENU
ENTER
RETURN
DVR-03_UK.book 30 ページ ２００３年７月２８日 月曜日 午後６時３０分