Pioneer DEH-P700BT - Manual (Page 31)

# If the difference between the ring volume and
caller
’s voice volume is big, overall volume level
may become unstable.
# Before disconnecting the cellular phone from
this unit, make sure to adjust the volume to a
proper level. If the volume is muted (zero level) on
your cellular phone, the volume level of your cel-
lular phone remains muted even after the cellular
phone is disconnected.
Notes
! The equalizer curve for the phone source is
fixed.
! When selecting the phone source, you can
only operate FADER (balance adjustment) in
the audio menu.
! When selecting the phone source, the fader
value is set to FADER :F15 as an initial setting.
Introduction of connection and
registration
1 Press MULTI-CONTROL to display the
main menu.
2 Use MULTI-CONTROL to select
CONNECTION.
The connection menu is displayed.
Turn to change the menu option. Press to se-
lect.
# You can also select this menu by pressing and
holding
PHONE/ / CONNECT on the ordinary
display.
3 Turn MULTI-CONTROL to select the
function.
PAIRED PHONE (paired phone)
—
BT HANDS FREE (new phone)
—SET PHONE
(phone registration)
—DISCONNECT PHONE
(disconnect phone)
—DELETE PHONE (delete
phone)
If the phone is not connected and not
paired
The following function can be operated.
! BT HANDS FREE (new phone)
If the phone is not connected but paired
The following functions can be operated.
! PAIRED PHONE (pair phone manually)
! BT HANDS FREE (new phone)
! DELETE PHONE (delete phone)
If the phone is connected but not paired
The following functions can be operated.
! SET PHONE (phone registration)
! DISCONNECT PHONE (disconnect phone)
! DELETE PHONE (delete phone)
If the phone is connected and paired
The following functions can be operated.
! DISCONNECT PHONE (disconnect phone)
! DELETE PHONE (delete phone)
Notes
! The device name is set to PIONEER RGB BT as
default. You can change the device name in
the initial setting. Refer to Editing device name
on page 51.
! PIN code is set to 0000 as the default. You
can change this code in the initial setting.
Refer to Entering PIN code for Bluetooth wire-
less connection on page 51.
Connecting and disconnecting
a cellular phone
Using a cellular phone to initiate a
connection
1 Display the connection menu.
Refer to Introduction of connection and regis-
tration on this page.
2 Use MULTI-CONTROL to select
BT HANDS FREE.
3 Use MULTI-CONTROL to select a group.
Push MULTI-CONTROL up or down to select a
group.
NOKIA (Nokia)
—STANDARD (standard)
# Normally select STANDARD. If the device of
Nokia is not paired to this unit, select
NOKIA.
# Push MULTI-CONTROL left or right to display
a group name or an ID.
4 Press MULTI-CONTROL to switch to
PAIRE FROM PHONE.
Push
MULTI-CONTROL up or down to switch
PAIRE FROM PHONE and SEARCH DEVICE.
Operating this unit
En
31
Section
02
Operating
this
unit