Pioneer DEH-P700BT - Manual (Page 41)

# If the ID and the password are requested, refer
to Entering the ID and the password on this page.
Entering the ID and the password
If the ID and the password are requested, read
the following instructions to enter the ID and
the password.
! Up to 20 characters can be entered for the
ID and up to 16 characters can be entered
for the password.
1 Press DISP to switch between alphabet
and numbers.
Press
DISP repeatedly to switch between the
following character types:
Alphabet
—Numbers and symbols
2 Push MULTI-CONTROL up or down to
select a letter.
3 Push MULTI-CONTROL left or right to
move the cursor to the previous or next
character position.
4 Press MULTI-CONTROL to determine
the ID and the password.
5 After entering the ID and password,
use your cellular phone to continue the
procedure.
Transferring entries to the
phone book
Phone books in your cellular phone can be
transferred to this unit by using your cellular
phone.
! 400 entries for each user (max. 3 users) can
be stored in the phone book. Each indepen-
dent entry can hold three phone numbers
and genres.
1 Display the function menu.
Refer to Introduction to advanced operations
on the previous page.
2 Use MULTI-CONTROL to select
PH BOOK TRANSFER.
3 Press MULTI-CONTROL to enter the
phone book transfer standby mode.
4 Use the cellular phone to perform
phone book transfer.
Perform phone book transfer using the cellu-
lar phone. For detailed instructions, refer to
the instruction manual that came with your
cellular phone.
When phone book transfer is completed,
DATA TRANSFERRED is displayed.
# The display indicates how many entries have
been transferred and the total number to be
transferred.
Setting the automatic connection
It is possible to set the automatic connection
between your cellular phone and this unit. If
this function is set to on, connection between
your cellular phone and this unit will take
place automatically as soon as the two devices
are less than a few meters apart.
! With some cellular phones, it may not be
possible to perform the automatic connec-
tion.
1 Display the function menu.
Refer to Introduction to advanced operations
on the previous page.
2 Use MULTI-CONTROL to select
AUTO CONNECT.
3 Press MULTI-CONTROL to turn auto-
matic connection on.
# To turn automatic connection off, press
MULTI-CONTROL again.
Note
Automatic connection is performed in the regis-
tration number order.
Setting automatic answering
1 Display the function menu.
Refer to Introduction to advanced operations
on the previous page.
Operating this unit
En
41
Section
02
Operating
this
unit