Pioneer HTP-SL100 - Manual (Page 5)

5
En
English
Connection
Connecting the cord
1 Attach one end of the supplied speaker cord to the rear
of the each speaker.
• Connect the wire with the colored marker to the red (+)
terminal; the plain wire to the black (–) terminal. Press down
the spring-loaded tab and insert the wire, as shown below.
Release the tab to secure the wire.
2 Connect the other ends of the cords to the amp’s speaker
output terminals (for more details, refer to your amp
instruction manual).
• These speaker terminals carry HAZARDOUS LIVE voltage. To
prevent the risk of electric shock when connecting or
disconnecting the speaker cords, disconnect the power cord
before touching any uninsulated parts.
• After connecting the plugs, pull lightly on the cords to make
sure that the ends of the cords are securely connected to the
terminals. Poor connections can create noise and
interruptions in the sound.
• If the cords’ wires happen to be pushed out of the terminals,
allowing the wires to come into contact with each other, it
places an excessive additional load on the receiver. This may
cause the amp to stop functioning, and may even damage the
receiver.
• When using a set of speakers connected to an receiver, you
won’t be able to obtain the normal stereo effect if the polarity
(+, –) of one of the speakers (left or right) is reversed.
Operation (S-SL100-LR/S-SL100CR)
Since the S-SL100-LR/S-SL100CR are designed as compact
satellite speakers, it is recommended that they be used in
combination with a sub-woofer to provide full base sound. In this
case, set your amplifier (receiver) speaker setting to “small” and
the crossover frequency to 200 Hz.
Specifications
S-SL100-LR/S-SL100CR
Enclosure. . . . . . . . Closed-box bookshelf type (magnetically shielded)
Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . 10 cm x 7 cm, full range
Impedance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Ω
Frequency range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100 Hz to 20 kHz
Sensitivity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .81 dB
Maximum input power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100 W
Exterior dimensions . . . . . . 86.5 (W) mm x 206 (H) mm x 85.5 (D) mm
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.7 kg
Supplied accessories (S-SL100-LR)
Speaker cord (4 m) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Non-skid pads . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Warranty card (European model only) . . . . . . . . . . . . . . . . . . . . . . . . . 1
Operating instructions (this document)
Supplied accessories (S-SL100CR)
Speaker cord (4 m) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Speaker cord (10 m) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Non-skid pads . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Warranty card (European model only) . . . . . . . . . . . . . . . . . . . . . . . . . 1
Operating instructions (this document)
S-SLW500
Enclosure. . . . . . . . . . . . . . . . . . . . . . . . . . . . Bass-reflex bookshelf type
Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16 cm cone
Impedance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Ω
Frequency range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35 Hz to 2.0 kHz
Sensitivity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .78 dB
Maximum input power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100 W
Exterior dimensions
Horizontal orientation. . . . 435 (W) mm x 121 (H) mm x 360 (D) mm
Vertical orientation . . . . . 108.5 (W) mm x 435 (H) mm x 360 (D) mm
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4.5 kg
Supplied accessories
Speaker cord (3 m) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Non-skid pads . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Seal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Warranty card (European model only) . . . . . . . . . . . . . . . . . . . . . . . . . 1
• The S-SL100-LR is shipped with two speaker systems per
package.
• The S-SL100CR is shipped with three speaker systems per
package.
• Specifications and design subject to possible modification
without notice, due to improvements.
is a trademark placed on a product with Pioneer’s Phase
Control technology. This technology enables high-grade sound
reproduction through each component by improving overall
phase matching.
© 2011 PIONEER CORPORATION.
All rights reserved.
Red (+)
Black (–) Red colored marker
S-SL100-LR_S-SL100CR_En.fm 5 ページ ２０１１年４月１２日 火曜日 午前１１時３１分