Pioneer CNDV-80MT - Manual (Page 13)

How to Upgrade Your Naviga-
tion
The programme is installed to the navigation sys-
tem using the application disc.
When installing the programme, you carry out
the following operations. When all the setup pro-
cedures are completed, you can use the naviga-
tion system.
The screen images used in this section are AVIC-
900DVD as an example.
• You cannot go back to the previous (pre-
upgrade) version of the application after
the software upgrade is completed. Also,
the map discs that were previously used
cannot be used. Instead, use the CNDV-
80MT DVDs as your new map discs.
1
Park your vehicle in a safe place.
Leave the engine on, and make sure that the
handbrake is applied.
2
Remove the current disc.
Press the EJECT button.
3
Insert the new Pioneer DVD Map Disc
into the disc loading slot.
When the upgraded programme has been
found, installation of the programme starts
immediately.
❒
If you cannot insert a disc completely or if
an inserted disc is not recognised, check
that the label side of the disc is up. Press
the EJECT button to eject the disc, and
check the disc for damage before inserting
the disc again.
While this screen appears, NEVER switch the
key position from ACC or turn the power to
the navigation system, off.
When the installation is complete, the open-
ing display appears.
If you use the remote control type, per-
form these steps before inserting the
upgrade disc.
1. Turn the engine off (or turn the ignition
switch off).
2. Remove the current display from the navi-
gation system.
3. Connect the touch panel display to the nav-
igation system.
(Refer to the Owner’s manual or installa-
tion manual for the display.)
4. Turn the engine on (or turn the ignition
switch on).
MAN-CNDV-80T-EN.fm Page 13 Wednesday, April 2, 2008 11:31 AM