Pioneer X-HM51DAB-K - Manual (Page 11)

Connections 03
11
En
Chapter 3:
Connections
CAUTION
• Be sure to turn off the power and unplug the power cord
from the power outlet whenever making or changing
connections.
• Connect the power cord after all the connections
between devices have been completed.
Speaker connection (X-HM51DAB
only)
• The provided speaker wire with the red tube is for the (+)
terminal. Connect the wire with red tube the (+)
terminal, and other wire to the (–) terminal.
CAUTION
• These speaker terminals carry HAZARDOUS LIVE
voltage . To prevent the risk of electric shock when
connecting or disconnecting the speaker cables,
disconnect the power cord before touching any
uninsulated parts.
• Make sure that the speaker cable cores do not become
exposed and make contact with other cable cores. This
may cause malfunction of the product.
• Do not allow the speaker cable core to come into contact
with the receiver body.
- If the speaker cable core comes into contact with any
metal portion of the receiver’s body, it may damage the
speakers and cause smoke and fire.
Insert speaker cables securely into the terminals and
check that the cable does not come out of easily.
X-HM51DAB only
• Do not connect any speakers other than those supplied
to this system.
• Do not connect the supplied speakers to any amplifier
other than the one supplied with this system.
Connection to any other amplifier may result in
malfunction or fire.
• Do not attach these speakers to the wall or ceiling. They
may fall off and cause injury.
• These speakers are magnetically shielded. However,
depending on the installation location, color distortion
may occur if the speaker system is installed extremely
close to the screen of a television set. If this happens,
turn off the television set, and then turn it on after 15 to
30 minutes. If the problem persists, move the speaker
system away from the television set.
XC-HM51DAB only
• You can use speakers with a nominal impedance
between 4  and 16 .
Note
• There is no difference between L and R speakers.
Cleaning the glossy finish of the speaker (X-
HM51DAB only)
• If you use a dusty or hard cloth or if you rub the screen
hard, the finish of the product will be scratched.
• If you clean the surface of the speaker system with a wet
cloth, water droplets on the surface may enter into the
product, resulting in malfunction.
• When cleaning the finish of the speaker system, gently
wipe it with a dry soft cloth.
SUBWOOFER
PREOUT
SPEAKERS
R L
+
X-HM51DAB
This unit’s rear panel
Red tube
Supplied
speaker wire
Left speaker Right speaker
X-HM51DAB_VXE8_En.book 11 ページ ２０１３年３月２２日 金曜日 午前９時１９分