01 before you start, What’s in the box, Loading the batteries in the remote control – Pioneer X-HM51DAB-K User Manual

Page 6: Using the remote control, Before you start, Before you start 01, Chapter 1

Advertising
background image

Before you start

01

6

En

Chapter 1:

Before you start

What’s in the box

Please confirm that the following accessories are in the box

when you open it.

• Remote control
• Power cord
• DAB/FM wire antenna
• AAA batteries (R03) x 2
• Speaker cord x 2 (X-HM51DAB only)
• iPad stand
• Warranty card
• Operating instructions (this document)

Loading the batteries in the
remote control

1

Open the rear lid and load the batteries as

illustrated below.

2

Close the rear lid.

CAUTION

• When inserting the batteries, make sure not to damage

the springs on the battery’s  terminals. This can cause

batteries to leak or over heat.

• Do not use any batteries other than the ones specified.

Also, do not use a new battery together with an old one.

• When loading the batteries into the remote control, set

them in the proper direction, as indicated by the polarity

marks ( and ).

• Do not heat batteries, disassemble them, or throw them

into flames or water.

• Batteries may have different voltages, even if they are the

same size and shape. Do not use different types of

batteries together.

• To prevent leakage of battery fluid, remove the batteries

if you do not plan to use the remote control for a long

period of time (1 month or more). If the fluid should leak,

wipe it carefully off the inside of the case, then insert new

batteries. If a battery should leak and the fluid should get

on your skin, flush it off with large quantities of water.

• When disposing of used batteries, please comply with

governmental regulations or environmental public

institution’s rules that apply in your country/area.

WARNING

Do not use or store batteries in direct sunlight or other

excessively hot place, such as inside a car or near a

heater. This can cause batteries to leak, overheat,

explode or catch fire. It can also reduce the life or

performance of batteries.

Using the remote control

The remote has a range of about 7 m at an angle of about 30º

from the remote sensor.

Keep in mind the following when using the remote control:

• Make sure that there are no obstacles between the

remote and the remote sensor on the unit.

• Remote operation may become unreliable if strong

sunlight or fluorescent light is shining on the unit’s

remote sensor.

• Remote controllers for different devices can interfere

with each other. Avoid using remotes for other

equipment located close to this unit.

• Replace the batteries when you notice a fall off in the

operating range of the remote.

INPUT

30°

7 m

30°

X-HM51DAB_VXE8_En.book 6 ページ 2013年3月22日 金曜日 午前9時19分

Advertising