Pioneer PDP-5080XA - Manual (Page 18)

Preparation 05
18
En
Attaching and removing speed clamps
Insert [1] into an appropriate hole on the rear of the plasma
television and snap [2] into the back of [1] to lock the clamp.
• Speed clamps are designed to be difficult to undo once in place.
Please attach them carefully.
• Use pliers to twist the clamp 90º, pulling outward. The clamp
may deteriorate over time and become damaged if removed.
• Be careful not to subject any connecting cables to strain.
Note
• Use the speed clamps as necessary.
Attaching the ferrite core
Attach the accessory ferrite core to the end of the power cord as
shown in the accompanying illustration. Use the provided cable tie
to prevent the ferrite core from slipping on the table.
If you do not do this, the plasma television will not conform to
mandatory CE standards.
Connecting the power cord
Note
• Disconnect the power cord from the power outlet when the
plasma television is not going to be used for a long period of
time.
• Insert the power plug in the AC outlet, after all other
components are connected.
1
2
1
2
3
4
Ferrite core
Cable tie
AC power cord
To power outlet
As close as possible
Europe, except UK and
Republic of Ireland
UK and Republic of Ireland
Power cord
Rear view