Resetting the system – Pioneer VSX-924-S User Manual
Page 74
74
Using other functions
09
Resetting the system
Use this procedure to reset all the receiver’s settings to the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to MULTI ZONE OFF.
! Disconnect the iPod and USB memory device from the receiver beforehand.
! Set the Control with HDMI to OFF (see
HDMI Setup
on
page 63
).
1 Switch the receiver into standby.
2 While holding down ENTER on the front panel, press u STANDBY/ON.
The display shows RESET c NO d.
3 Select ‘RESET’ using PRESET
k/l, then press ENTER on the front panel.
The display shows RESET? OK.
4 Press ENTER to confirm.
OK appears in the display to indicate that the receiver has been reset to the factory default settings.
! Note that all settings will be saved, even if the receiver is unplugged.
Default system settings
Setting
Default
Digital Video Converter
OFF
SPEAKERS
SB/FH ON
Speaker System
Normal(SB/FH)
Speaker Setting
Front
SMALL
Center
SMALL
FH/FW
SMALL
Surr
SMALL
SB
SMALLx2
SW
YES
Surround Position
ON SIDE
Crossover
80Hz
X-Curve
OFF
DIMMER
Medium bright
Inputs
See
Input function default and possible settings
on
page 39
.
Input Volume Absorber
All Inputs
0dB
HDMI
HDMI Audio
AMP
Control
OFF
Control Mode
--- (OFF)
ARC (Audio Return Channel)
--- (OFF)
PQLS
--- (AUTO)
Standby Through
OFF
DSP
Power On Level
LAST
Volume Limit
OFF
Mute Level
FULL
Setting
Default
Phase Control
ON
Auto Sound Retriever
iPod/USB, INTERNET RADIO, PANDORA
(Australian model only), MEDIA SERVER,
FAVORITES, BT AUDIO input function
ON
Other input functions
OFF
Sound Delay
0 ms
Dual Mono
CH1
DRC
AUTO
LFE Attenuate
0dB
Auto delay
OFF
Digital Safety
OFF
Effect Level
ALC (Auto Level Control)
50
PL II Music Options
Center Width
3
Dimension
0
Panorama
OFF
Neo:X Options
Center Gain
Neo:X CINEMA: 1.0
Neo:X MUSIC: 0.3
Neo:X GAME: 1.0
PL IIz Options
Height Gain
MID
All Inputs
Listening Mode (2 ch/multi ch)
AUTO SURROUND
Listening Mode (Headphones)
STEREO
See also
Setting the Audio options
on
page 67
for other default DSP settings.
MCACC
MCACC Position Memory
M1. MEMORY 1
Channel Level (M1 to M6)
0.0 dB
Speaker Distance (M1 to M6)
3.00 m
Standing Wave (M1 to M6)
ATT of all channels/filters
0.0 dB
SWch Wide Trim
0.0 dB
EQ Data (M1 to M6)
All channels/bands
0.0 dB
EQ Wide Trim
0.0 dB
Network
Network Standby
OFF
DHCP
ON