Pioneer AVIC-F250 - Manual (Page 17)

Black plate (17,1)
On first-time startup
When you use the navigation system for the
first time, an initial setup process starts auto-
matically. Follow the steps below.
1 Start the engine to boot up the system.
2 Wait approximately 10 seconds, and
then press the MODE button of the AV re-
ceiver.
After a short pause, the navigation splash
screen appears.
3 Set the video output selector switch ac-
cording to your AV receiver.
p If the screen remains black after pressing
the MODE button of the AV receiver, set the
switch to the other side.
= For details, refer to Checking part names
and functions on page 15.
4 Select the language that you want to
use on the screen, then touch [Done].
p Later you can change it in “Regional” set-
tings.
= For details, refer to Customising the regional
settings on page 62.
The navigation system will restart and the
“End User Licence Agreement” screen is dis-
played.
5 Read the disclaimer carefully, checking
its details, and then touch [Accept] if you
agree to the conditions.
The configuration wizard starts.
6 Touch [Next] to continue.
7 Select the language that you want to
use for voice guidance messages, then
touch [Next].
p Later you can change it in “Sound and
Warnings ” settings.
= For details, refer to Setting the volume and
the guidance voice for navigation system on
page 56.
8 If needed, modify the time format and
unit settings, then touch [Next].
p Later you can change it in “Regional” set-
tings.
= For details, refer to Customising the regional
settings on page 62.
<127075024473>17
Engb
17
Chapter
03
Before
you
start
Before you start