Pioneer AVIC-F250 - Manual (Page 48)

Black plate (48,1)
Modifying the route
When navigation is already started, there are
several ways to modify the current route. The
following sections describe some of those op-
tions.
Selecting a new destination
when already having a route
If you already have a recommended route and
you select a new destination, the navigation
system will ask you whether to start a new
route, add a new waypoint to the route or ap-
pend the newly selected destination at the end
of the current route.
! New Route:
Touch this key to plan a new route to the
newly selected location. The previous desti-
nation and waypoint(s) are deleted.
! Waypoint:
Touch this key to add the newly selected lo-
cation as a waypoint to your route. The
other destinations of the route remain in-
tact.
p The new waypoint is placed among des-
tinations to keep the route optimal. To
decide where a waypoint to appear, use
the
“Edit Route” menu.
! Final Destination:
Touch this key to append the newly se-
lected destination at the end of the route.
The other destinations of the route remain
intact. The previous final destination is now
the last waypoint.
Setting a new starting position
for the route
For normal navigation, all routes are planned
from the current position. In order to check fu-
ture routes, simulate them or see their length
in time and distance, you can turn off the GPS
receiver. Then you can set the starting point of
the route to a different location than the cur-
rent GPS position.
1 Touch [Menu] on the map screen.
The “Navigation Menu” screen appears.
= For details of the operations, refer to Screen
switching overview on page 19.
2 Touch [My Route] on the
“Navigation
Menu
” screen.
3 Touch [Edit Route] when you already
have a route.
4 Touch on the first line (normally the
current GPS position) and confirm your ac-
tion on the warning message screen.
<127075024473>48
Engb
48
Chapter
08 Checking and modifying the current route