Pioneer AVIC-F250 - Manual (Page 18)

Black plate (18,1)
9 If needed, modify the default route
planning options, then touch [Next].
p Later you can change them in “Route Set-
tings ”.
= For details, refer to Modifying the route cal-
culation conditions on page 42.
p You can restart the configuration wizard
later from the “Settings” menu.
= For details, refer to Starting the configuration
wizard on page 62.
10 Touch [Finish].
The initial setup is now complete.
After touching [
Finish], the “Navigation
Menu
” screen appears and you can start
using the navigation system.
Regular startup
1 Start the engine to boot up the system.
2 Press the MODE button of the AV recei-
ver.
After a short pause, the navigation screen ap-
pears.
p The display will turn off if you press the
MODE button of the AV receiver immedi-
ately after the navigation system restarts, so
wait (approximately 10 seconds) after re-
start before pressing the
MODE button.
<127075024473>18
Engb
18
Chapter
03 Before you start