Pioneer AVIC-F8430BT - Manual (Page 155)

p Even if this setting is “Off”, the navigation
system will mute or attenuate the AV
source volume when the mute signal is out-
put via MUTE lead.
1 Display the “AV System Settings”
screen.
= For details, refer to Displaying the screen for
AV system settings on page 152.
2 Touch [Mute].
Each touch of [ Mute] changes the settings as
follows:
! Guide/Tel: The volume is muted or attenu-
ated according to the following conditions.
— When the navigation outputs the gui-
dance voice.
— When you use a mobile phone via
Bluetooth technology (dialling, talking,
incoming call).
! Tel (default): The volume is muted or attenu-
ated when you use a mobile phone via
Bluetooth technology (dialling, talking, in-
coming call).
! Off: The volume does not change.
p AV source volume returns to normal when
the corresponding action ends.
Switching the muting/
attenuation level
You can select the muting/attenuation level of
“Mute”. This setting is also effective for a
mute signal that has been received from the
MUTE lead connected to the navigation unit.
p This menu is not available when AV source
is
“Off”.
1 Display the
“AV System Settings”
screen.
= For details, refer to Displaying the screen for
AV system settings on page 152.
2 Touch [Mute Level].
Each touch of [ Mute Level] changes the set-
tings as follows:
! 20dB (default): The volume becomes 1/10.
! 10dB: The volume becomes 1/3.
! All: The volume becomes 0.
p When you select “All”, no audio adjust-
ments are possible during the sound is
turned off.
p When you select “20dB” or “10dB”, no
audio adjustments are possible during the
sound is attenuated.
p AV source volume returns to normal when
the corresponding action ends.
p Even when a mute signal has been received
from MUTE lead connected to the naviga-
tion unit, navigation voice guidance cannot
be attenuated or muted.
Switching Auto PI seek
The navigation system can automatically
search for a different station with the same
programming, even during preset recall.
p “Auto PI” can be set only when the source
is selected to
“Off”.
1 Display the
“AV System Settings”
screen.
= For details, refer to Displaying the screen for
AV system settings on page 152.
2 Touch [Auto PI].
Each touch of [ Auto PI] changes the settings
as follows:
! Off (default):
Deactivates the Auto PI seek function.
! On:
Activates the Auto PI seek function.
Setting the FM tuning step
Normally the FM tuning step employed by
seek tuning is 50 kHz. When
“AF” or “TA” is
on, the tuning step automatically changes to
100 kHz. But you can set the tuning step to
50 kHz when
“AF” or “TA” is on.
p “FM Step” can be set only when the source
is selected to
“Off”.
Engb
155
Chapter
27
Customising
pr
eferences
Customising preferences