Pioneer STZ-D10T-G - Manual (Page 9)

9 En
 Using the remote control
The remote has a range of about 7 m (23 ft.) at an angle of about 30º from the remote sensor.
CAL L
ME NU
TOO LS
STA NDB Y/O N
8 SK IP
8 SK IP
TEM PO
TEM PO
VOL FUN C
ENT ER
ME MO
BAT TLE
RHY THM
DJ MIX
EXI T
CU E
30°
30°
7 m (23 ft.)
STZ-D10T
Keep in mind the following when using the remote control:
! Make sure that there are no obstacles between the remote and the remote sensor on the unit.
! Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the unit’s remote sensor.
! Remote controllers for different devices can interfere with each other. Avoid using remotes for other equipment located close to this unit.
Connecting the unit to the AC adapter / Installing batteries
This unit can operate on power from the supplied AC adapter, or from batteries.
! Batteries for the device are not included. Please use six AA size batteries, available at retailers. (Use of alkaline or nickel-metal hydride batteries
is recommended. Use of manganese batteries and certain alkaline or nickel-metal hydride batteries may not allow use of the full capacity of the
device.)
! When connecting the device to a PC, always use the AC adapter.
Connecting the AC adapter
CAUTION
! The unit should be disconnected by removing the mains plug from the wall socket when not in regular use, e.g., when on vacation. Before unplug-
ging the power cord, switch the power into standby.
! Handle the power cord by the plug part. Do not pull out the plug by tugging the cord, and never touch the power cord when your hands are wet, as
this could cause a short circuit or electric shock. Do not place the unit, a piece of furniture, or other object on the power cord or pinch the cord in
any other way. Never make a knot in the cord or tie it with other cables. The power cords should be routed so that they are not likely to be stepped
on. A damaged power cord can cause a fire or give you an electric shock. Check the power cord once in a while. If you find it damaged, ask your
nearest Pioneer authorized independent service company for a replacement.
! Make sure to grasp the body of the AC adapter when removing it from the power outlet. If you pull the power cord, it may become damaged which
could lead to fire and/or electrocution.
! Do not attempt to plug in or remove the AC adapter with wet hands. This may result in electrocution.
! Do not insert the power cord of AC adapter into a power outlet where the connection remains loose despite inserting the prongs all the way into the
outlet. Heat may be generated which could lead to fire. Consult with the retailer or an electrician regarding replacement of the power outlet.
Store the AC adapter out of the reach of children and infants.
The AC adapter cord may accidentally wind around the neck and it may cause suffocation.
1 Attaching the power plug to the AC adapter.
Slide the power plug along the guide rails of the power adapter as shown in the figure below until there is an audible click.
! Use the appropriate power plug for the respective country’s power outlet.
Two-pin flatbladed plug
European two-pin plug