Pioneer X-SMC55-S - Manual (Page 28)

Connect to network 08
28
En
6 From the menu on the left, select “Network
Configuration”.
7 If using a wireless LAN connection, input the
router’s SSID, then select the “Security” item set
on the router.
Also, if input of a fixed IP is required, set DHCP to OFF here
and make the setting.
8 If a password is requested, input it here.
9 When settings are completed, click on
“Apply”.
The unit will automatically power down.
10 Press  STANDBY/ON.
When the power is completely on, the NETWORK indicator
will light white, indicating that settings are completed.
Note
• You can set the network as in the above by connecting
this unit’s IP address via the Safari browser even if Web
control isn’t selected.
E: Connection settings using an iOS
device
You can apply iPod/iPhone/iPad (iOS device with iOS ver 5.0
or later)’s Wi-Fi settings to this unit.
Confirm that the iOS device has a wireless connection to your
router.
1 Be sure the LAN cable is not connected to the
unit.
If your iPod/iPhone/iPad Wi-Fi is set to a setting that the
product cannot connect to, such as IEEE 802.11n, you will be
unable to apply those settings. Execute these steps after
checking the Wi-Fi settings of your iPod/iPhone/iPad.
2 Unlock your iPod/iPhone/iPad that Wi-Fi
connection is completed.
3 Plug the power cord into an AC outlet. Press
 STANDBY/ON.
4 Press iPod or USB on the remote control.
If you press iPod, connect iPod/iPhone to the iPod/iPhone
dock. If you press USB, connect the iOS device to the USB
terminal.
5 Press NW SETUP.
The NETWORK indicator will flash blue.
6 Tap “Allow” on iPod/iPhone/iPad.
The Wi-Fi settings of your iPod/iPhone/iPad are applied to the
unit.
When the connection is complete, the NETWORK indicator
will briefly change to flashing blue, then light steadily white.
The NETWORK indicator will flash white when the signal is
weak.