Pioneer X-SMC55-S - Manual (Page 43)

Additional information 14
43
En
Wireless LAN
Problem Check Remedy
Network cannot be accessed
via wireless LAN.
Is the LAN cable connected to the
unit?
Be sure the LAN cable is not connected to the unit, and then the
unit OFF and ON again.
Is the Network type set to Wired? In the Network configuration screen in the Web browser, set
Network type to Auto.
This unit and base unit (wireless LAN
router, etc.) are too far apart or there
is an obstacle between them.
Improve the wireless LAN environment by moving the unit and base
unit closer together, etc.
There is a microwave oven or other
device generating electromagnetic
waves near the wireless LAN
environment.
Use the system in a place away from microwave ovens or others
device generating electromagnetic waves.
Avoid using devices generating electromagnetic waves as much as
possible when using the system with the wireless LAN.
Multiple wireless devices are
connected to the wireless LAN router.
When connecting multiple wireless devices, their IP addresses
must be changed.
Wireless LAN connections cannot be
established between the unit and
base unit (wireless LAN router, etc.).
The unit must be set in order to establish wireless LAN
connections. See Connecting using wireless LAN on page 12.
The IP address settings of the unit
does not match the settings of the
wireless LAN router, etc.
Check the IP address settings of the unit (including the DHCP
setting).
If the unit’s DHCP setting is on, turn the unit’s power off, then turn
the power back on.
Check that the IP address of the unit matches the settings of the
wireless LAN router, etc.
If the unit’s DHCP setting is off, set an IP address matching the
network of the base unit (wireless LAN router, etc.).
For example, if the wireless LAN router’s IP address is
“192.168.1.1”, set the unit’s IP address to “192.168.1.XXX” (*1), the
subnet mask to “255.255.255.0”, the gateway and DNS to
“192.168.1.1”.
(*1) Set the “XXX” in “192.168.1.XXX” to a number between 2 and
248 that is not assigned to other devices.
The access point is set to conceal the
SSID.
In this case, the SSID may not be displayed on the access point list
screen. If not, set the SSID, etc., by making the wireless LAN
settings on the unit manually.
The access point’s security settings
use WEP 152-bit length code key or
shared key authentication.
The unit does not support WEP 152-bit length code key or shared
key authentication.
Doesn’t play properly when
using the Wireless Direct
function.
The Wireless Direct function may not operate properly depending
on the condition of signal reception and the wireless LAN device
connected. In such cases, bring the wireless devices closer
together and in other ways improve the conditions for wireless LAN
reception.
Set to quick start mode, but
during standby AirPlay and
DMR do not work.
Are you using Connecting to a router
without WPS-PBC function or
Wireless Direct?
If you turn the power OFF immediately after using Connecting to a
router without WPS-PBC function or Wireless Direct, quick start
mode will be temporarily turned OFF. Once the power is turned ON
again, the quick start mode settings will be restored.
Have you removed the power cord? If you remove and then reinsert the power cord, quick start mode
will be temporarily turned OFF. Once the power is turned ON again,
the quick start mode settings will be restored.