Pioneer SC-LX73 - Manual (Page 128)

Additional information 13
128
En
HOME MEDIA GALLERY (SC-LX83 only)
Symptoms Causes Remedies
Cannot access the network. The LAN cable is not firmly connected. Firmly connect the LAN cable (page 37).
The router is not switched on. Switch on the router.
Internet security software is currently installed in
the connected component. There are cases where a component with Internet
security software installed cannot be accessed.
The audio component on the network which has
been switched off is switched on. Switch on the audio component on the network
before switching on this receiver.
Playback does not start while
‘Connecting...’ continues to
be displayed. The component is currently disconnected from
this receiver or the power supply. Check whether the component is properly
connected to this receiver or the power supply.
The PC or Internet radio is not
properly operated. The corresponding IP address is not properly set. Switch on the built-in DHCP server function of your
router, or set up the network manually according to
your network environment (page 113).
The IP address is being automatically configured. The automatic configuration process takes time.
Please wait.
The audio files stored on
components on the network,
such as a PC, cannot be
played back. Windows Media Player 11 or Windows Media
Player 12 is not currently installed on your PC. Install Windows Media Player 11 or Windows
Media Player 12 on your PC (page 61).
Audio files were recorded in formats other than
MP3, WAV (LPCM only), MPEG-4 AAC, FLAC, and
WMA. Play back audio files recorded in MP3, WAV
(LPCM only), MPEG-4 AAC, FLAC, or WMA. Note
that some audio files recorded in these formats
may not be played back on this receiver.
Audio files recorded in MPEG-4 AAC or FLAC are
being played back on Windows Media Player 11 or
Windows Media Player 12. Audio files recorded in MPEG-4 AAC or FLAC
cannot be played back on Windows Media Player
11 or Windows Media Player 12. Try using another
server. Refer to the operation manual supplied
with your server.
The component connected to the network is not
properly operated. Check whether the component is affected by
special circumstances or is in the sleep mode.
Try rebooting the component if necessary.
The component connected to the network does
not permit file sharing. Try changing the settings for the component
connected to the network.
The folder stored on the component connected to
the network has been deleted or damaged. Check the folder stored on the component
connected to the network.
Cannot access the
component connected to the
network. The component connected to the network is not
properly set. If the client is automatically authorized, you need
to enter the corresponding information again.
Check whether the connection status is set to “Do
not authorize”.
There are no playable audio files on the
component connected to the network. Check the audio files stored on the component
connected to the network.
Audio playback is undesirably
stopped or disturbed. The audio file currently being played back was not
recorded in a format playable on this receiver. Check whether the audio file was recorded in a
format supported by this receiver.
Check whether the folder has been damaged or
corrupted.
Note that there are cases where even the audio
files listed as playable on this receiver cannot be
played back or displayed (page 66).
The LAN cable is currently disconnected. Connect the LAN cable properly (page 37).
There is heavy traffic on the network with the
Internet being accessed on the same network. Use 100BASE-TX to access the components on
the network.
When in the DMR mode, depending on the
external controller being used, playback may be
interrupted when a volume operation is
performed from the controller. In this case, adjust the volume from the receiver
or remote control.