Pioneer SC-LX73 - Manual (Page 96)

Controlling the rest of your system (In case of SC-LX73) 10
96
En
Programming a Multi operation or a
shutdown sequence
1 Press and hold R.SETUP, then press “3” for three
seconds.
The LED flashes continuously.
• To cancel the preset setup mode press R.SETUP.
2 Press the input function button (or  SOURCE
button).
For Multi operations, press the input function you wish to
program (for example, if you want to start the sequence
by switching on your DVD player, press DVD).
1
For System off, press the  SOURCE button.
The LED blinks twice and flashes continuously.
3 If necessary, press the input function button for the
component whose command you want to input.
This is only necessary if the command is for a new
component (input function).
4 Select the button for the command you want to
input.
The LED blinks once and flashes continuously.
• You don’t need to program the receiver to switch on
or off. This is done automatically.
With Pioneer components, you don’t need to program
the power to switch off in a shutdown sequence (except
DVD recorders).
5 Repeat steps 3 to 4 to program a sequence of up to
five commands.
If you press
R.SETUP before programming is completed,
commands programmed up to that point will be stored.
6 Press R.SETUP to exit the programming mode.
Using multi operations
1 Press MULTI OPERATION.
The LED flashes continuously.
2 Within five seconds, press an input function
button that has been set up with a multi operation.
The receiver switches on (if it was in standby) and the
programmed multi operation is performed automatically.
Using System off
1 Press MULTI OPERATION.
The LED flashes continuously.
2 Within five seconds, press  SOURCE.
The command sequence you programmed will run, then
all Pioneer components will switch off
2
, followed by this
receiver (switch of all the zones becomes off).
Erasing the settings for the multi-operation
This erases all the settings programmed in the remote
control for the multi-operation.
1 Press and hold R.SETUP, then press “8” for three
seconds.
The LED flashes continuously.
• To cancel the preset setup mode press R.SETUP.
2 Press the input function button containing the
program you want to cancel or the  SOURCE button
for three seconds.
If the LED lights for one second, the erasing has been
successfully completed.
Note
1 With Multi operation, the HDMI and TV CTRL settings cannot be made. For other settable input functions, see Setting the remote to control
other components on page 93.
2 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes are sent.