Pioneer RCS-55 - Manual (Page 53)

Getting started 04
53
En
English
• Press RECORDER to switch the recorder into
standby.
Playing DVD discs
The table below shows the basic playback controls for
DVD-Video, and recordable DVD discs.
Playing audio CDs and MP3s
The table below shows the basic playback controls for
audio CDs and MP3 files.
Note
• If you want to play a DTS audio CD, make sure the
recorder is connected to a DTS-compatible amp/
receiver with a digital connection. Noise will be
output through the analog outputs. Also make sure
that
STEREO is selected using the AUDIO button
(see Switching audio channels on page 62).
• You can’t use scanning when playing MP3 files.
Playing Video CDs
The table below shows the basic playback controls for
Video CDs.
Some discs feature Playback Control (PBC for short)
menus. These discs show PBC in the display when you
load them and display a menu on-screen from where you
can select what to watch.
Press to start or restart playback.
Press to pause playback; press again to
restart playback.
Press to stop playback.
You can resume playback from the same
point by pressing
. (Press again to
cancel the resume function.)
• During playback, press to start scan-
ning. Press repeatedly to increase the
scanning speed.
Press to skip to previous/next chapter/title.
(You can also use the front panel
+/– but-
tons to do this during playback.)
(Commercial skip). Each press skips for-
ward progressively up to a maximum of
ten minutes.
• Except VR mode: during playback, enter a
chapter number then press ENTER to skip
directly to that chapter within the currently
playing title.
On some discs, you can also use the num-
ber buttons to select numbered items in
the disc menu.
• VR mode only: d uring playback, enter a
title number then press ENTER .
• All: Press CLEAR to clear a number
entry and start again.
During playback, press to start slow-
motion playback. Press repeatedly to
change the playback speed.
While paused, press to advance a single
frame in either direction.
Press to display the ‘top’ menu or menu of
a DVD-Video disc (these are often the
same).
Use the cursor buttons to navigate DVD-
Video disc menus; press
ENTER to select
items.
Press to return to the previous level of a
DVD-Video disc menu.
PREV NEXT
CM SKIP
CLEAR
ENTER
STEP/SLOW
DVD MENU
TOP MENU
ENTER
RETURN
Press to start playback.
Press to pause playback; press again to
restart playback.
Press to stop playback.
Audio CD only: Press to start scanning.
Press again to increase the scanning
spee
d . (There are two scan spee d s; the
current scan spee d is shown on-screen.)
Press to skip to previous/next track (or
folder for MP3 disc). (You can also use the
front panel
+ / – buttons to d o this d uring
playback.)
D uring playback, enter a track (or folder)
number then press ENTER to skip d irectly
to that track.
Press
CLEAR to clear a number entry an d
start again.
Press to start or restart playback.
Press to pause playback; press again to
restart playback.
Press to stop playback.
You can resume playback from the same
point by pressing
. (Press again to
cancel the resume function.)
PREV NEXT
CLEAR
ENTER
DVR-230_UK.book Page 53 Thursday, July 7, 2005 3:24 PM