Pioneer VSX-519V-K - Manual (Page 25)

Controls and displays 04
25
En
English
Français
Italiano
Español
Nederlands
Deutsch
HDD*, DVD*, VCR*
These buttons switch between the hard
disk, DVD and VCR controls for HDD/DVD/
VCR recorders.
TEST TONE
Outputs the test tones on each channel.
Use the
/ buttons to select the channel
and use the / buttons to adjust the
level on each channel. Pressing TEST
TONE again exits the test tone mode.
CH SELECT
Press repeatedly to select a channel, then
use
+/– to adjust the level (page 34).
CH SELECT +/–
Use to adjust the channel levels.
SPEAKERS
Use to change the speaker system on or off
(page 32).
SLEEP
Press to change the amount of time
before the receiver switches into standby
(
30 min – 60 min – 90 min – Off). You can
check the remaining sleep time at any time
by pressing
SLEEP once.
DIMMER
Dims or brightens the display. The
brightness can be controlled in four steps.
12  SOURCE
Turns on or off the power of the Pioneer DVD/
DVR units when
BD or DVR is selected using
the MULTI CONTROL buttons.
13 TV CONTROL buttons
These buttons can control only be used with
Pioneer flat screen TVs.

Use to turn on/off the power of the TV.
INPUT
Use to select the TV input signal.
CH +/–
Use to select channels.
VOL +/–
Use to adjust the volume on your TV.
14 MASTER VOLUME +/–
Use to set the listening volume.
15 MUTE
Mutes/unmutes the sound.
16 DISPLAY
Switches the display of this unit. The input
name, listening mode or sound volume can be
checked by selecting an input source.
17 SHIFT
Press to access the ‘boxed’ commands (above
the buttons) on the remote. These buttons are
marked with an asterisk (
* ) in this section.
This button is also used for operating ZONE 2
(page 37).
VSX_519V_MY.book 25 ページ ２００９年１月１６日 金曜日 午後７時３２分