Pioneer VSX-519V-K - Manual (Page 44)

Additional information 10
44
En
Broadcast stations cannot be
selected automatically. • Connect an outdoor antenna (refer to page 15).
No sound from surround or
center speakers. • Connect the speakers properly (refer to page 16).
• Refer to Speaker setting on page 33 to check the speaker settings.
• Refer to Channel level on page 34 to check the speaker levels.
No sound from subwoofer. • Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it’s turned up.
• The Dolby Digital or DTS source you are listening to may not have
an LFE channel.
• Switch the subwoofer setting in Speaker setting on page 33 to
YES
or PLUS.
• Switch the LFEATT (LFE Attenuate) on page 31 to LFEATT 0 or
LFEATT 10.
The PHASE CONTROL feature
doesn’t seem to have an
audible effect.
• If applicable, check that the lowpass filter switch on your
subwoofer is off, or the lowpass cutoff is set to the highest frequency
setting. If there is a
PHASE setting on your subwoofer, set it to 0º (or
depending on the subwoofer, the setting where you think it has the
best overall effect on the sound).
• Make sure the speaker distance setting is correct for all speakers
(see Speaker Distance on page 35).
Noise during playback of a
cassette deck. • Move the cassette deck further from your receiver, until the noise
disappears.
No sound is output or a noise
is output when software with
DTS is played back. • Set the digital volume level of the player to full, or to the neutral
position.
• Make sure the player’s settings are correct and/or the DTS signal
out is on. Refer to the instruction manual supplied with the DVD
player.
• Set the input signal type to
C1/O1/O2 (DIGITAL) (see Choosing the
input signal on page 32).
During a playback search,
noise is output from a DTS
compatible CD player. • This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
Everything seems to be set up
correctly, but the playback
sound is odd. • Check that the positive/negative speaker terminals on the receiver
are matched with the corresponding terminals on the speakers (see
Connecting the speakers on page 16).
Can’t operate the remote
control. • Replace the batteries (refer to page 20).
• Operate within 7 m, 30
° of the remote sensor on the front panel
(refer to page 5).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
The display is dark or off. • Press DIMMER on the remote repeatedly to return to the default.
Problem Remedy
VSX_519V_MY.book 44 ページ ２００９年１月１６日 金曜日 午後７時３２分