Pioneer VSX-519V-K - Manual (Page 43)

Additional information 10
43
En
English
Français
Italiano
Español
Nederlands
Deutsch
Chapter 10:
Additional information
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie
in another component. Investigate the other components and electrical appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest
Pioneer authorized service center or your dealer to carry out repair work.
• If the unit does not operate normally due to external effects such as static electricity
disconnect the power plug from the outlet and insert again to return to normal operating
conditions.
Problem Remedy
The power does not turn on. • Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the
rear panel. This could cause the receiver to shut off automatically.
• If the power shuts off automatically, take the unit to your nearest
Pioneer authorized service center or your dealer for servicing.
No sound is output when a
function is selected. • Make sure the component is connected correctly (refer to
Connecting up on page 7).
• Press
MUTE on the remote control to turn muting off.
• Press SIGNAL SEL to select the proper input signal (see Choosing
the input signal on page 32).
No image is output when a
function is selected. • Make sure the component is connected correctly (refer to
Connecting up on page 7).
• Select the correct component (use the
MULTI CONTROL buttons).
• Check The Input Assign menu on page 35 to make sure you’re
assigned the correct input.
• The video input selected on the TV monitor is incorrect. Refer to the
instruction manual supplied with the TV.
Considerable noise in radio
broadcasts. • Connect the antenna (page 15) and adjust the position for best
reception.
• Route any loose cables away from the antenna terminals and wires.
• Fully extend the FM wire antenna, position for best reception, and
secure to a wall (or connect an outdoor FM antenna).
• Connect an additional internal or external AM antenna (page 15).
• Turn off equipment causing interference or move it away from the
receiver (or move antennas farther away from equipment causing
noise).
VSX_519V_MY.book 43 ページ ２００９年１月１６日 金曜日 午後７時３２分