The initial setup menu 15 – Pioneer DVR-550H-K User Manual

Page 122

Advertising
background image

The Initial Setup menu

15

122

En

4:3 Video Output

Full

Select if your HDMI TV allows you to change the
aspect ratio.

Normal

Select if your HDMI TV does not allow you to change
the aspect ratio. 4:3 video will be shown with bars on
each side.

Colour

RGB (0–255)

Use if colours are weak and black appears to ‘float’
on the

RGB (16–235)

setting.

RGB (16–235)

Use this setting if colours appear overly rich and the
black too deep on the

RGB (0–255)

setting.

YCbCr 4:2:2

The video signal is output as a 10-bit YCbCr 4:2:2
component signal. This is the standard setting for
HDMI-compatible devices.

YCbCr 4:4:4

The video signal is output as a 8-bit YCbCr 4:4:4
component signal.

• Depending on the connected device some settings may not be available.
• When a DVI device is connected, the

YCbCr 4:2:2

and

YCbCr 4:4:4

options are not available.

• You cannot choose

YCbCr 4:2:2

when the

Screen Resolution

is set to

720 x 576i (720x480i)

.

Audio Output

Auto •

Dolby Digital, MPEG and DTS sources are output as
a bitstream signal. However, depending on the

Audio Out

setting, number of audio channels, and

the HDMI-connected device, Linear PCM audio may
be output.

PCM

All audio signals are converted to Linear PCM
(except DTS).

Bitstream Priority

Select if the connected device is compatible with
bitstream audio.

This setting is not available when a DVI device is connected

.

Options

On Screen Display

On •

The recorder displays operation displays (

Stop

,

Play

,

etc.) on-screen.

Off

Switches off the on-screen operation displays.

Front Panel Display On •

The time is shown in the front panel display when the
recorder is in standby.

Off

The front panel display is switched off in standby .

Remote Control
Mode

Recorder 1–3

(default: Recorder 1)

If you are using more than one recorder in the same
room, set them to different IDs. This setting sets the
recorder ID; to change the remote controller ID, press
and hold

RETURN

then press

1

,

2

or

3

to set. The

remote will only control a recorder with the same ID.

Setting

Options

Explanation

DVR550HK_YXVSN5_EN.book 122 ページ 2007年4月5日 木曜日 午後6時51分

Advertising