Pioneer AVIC-X1 - Manual (Page 111)

109
Appendix
NAVI/AV
Error Messages
When problems occur with disc playback, an error message appears on the display. Refer to the table
below to identify the problem, then take the suggested corrective action. If the error persists, contact
your dealer or your nearest PIONEER Service Centre.
The messages in “( )” will appear on the sub-display.
Route Setting Information
Route search specifications
Your Navigation System sets a route to your desti-
nation by applying certain built-in rules to the
map data. This section provides some useful
information about how a route is set.
• When a route is calculated, the route and
voice guidance for the route is automati-
cally set. Also, for day or time traffic regu-
lations, only information about traffic
regulations at the time when the route was
calculated is shown. One-way streets and
street closures may not be taken into con-
sideration. For example, if a street is open
during the morning only, but you arrive
later, it would be against the traffic regula-
tions so you cannot drive along the set
route. When driving, please follow the
actual traffic signs. Also, the system may
not know some traffic regulations.
• Update Navigation DVDs are available for
purchase from your local Pioneer dealer
that includes the most current map and
point of interest information. Contact your
local Pioneer dealer for details.
The maximum number of registra-
tions has been completed. Please
clear existing registered items and
re-register current item. If there are already 300 items when
you attempt to register an item in the
Address Book. Delete some destinations as appro-
priate.
Memory is full. When the total 300 resistered points
are in the CD-R and Address Book,
you attempt moving an item to the
Address Book from CD-R. Delete unnecessary data and try to
register again.
Irregular character strings. Please
input again. A symbol that cannot be pronounced
was entered. Enter a word that can be pro-
nounced.
An error has occurred. Please note
the following error code and switch
power off. In the case of a system failure. Note down the error code shown on
the screen; turn off the power, and
then contact your nearest Pioneer
service facility.
DVD Player is overheating. Discon-
tinue until temperature drops. The built-in DVD drive has over-
heated. Cut the power off, and wait for a
while before turning the power on
again.
Message When What to do
Message Cause Action (See)
Error-02
(ERROR-20, ERROR-
21, ERROR-22) Dirty Clean disc.
Scratched disc Replace disc.
The disc is loaded upside down Check that the disc is loaded correctly.
Error-05-82
(ERROR-50) Electrical or mechanical Press RESET button. (“Hardware manual”
and refer to page 103 in this manual.)
DIFFERENT REGION
DISC (REGION ERR) The disc does not have the same region
number as this unit Replace the DVD video with one bearing the
correct region number.
NON PLAYABLE DISC
(NON-PLAY) This type of disc cannot be played by this
unit Replace the disc with one this unit can play.
THERMAL PROTEC-
TION IN MOTION
(TEMP) The temperature of this unit is outside of
the normal operating range Wait until the unit’s temperature returns to
within normal operating limits.
CRB1903B_ENGLISH.book Page 109 Friday, April 30, 2004 9:27 PM