Belkin P74393UK - Manual (Page 14)

11
Setup for Advanced Users
11
se
ct
io
n
2
1
3
4
5
6
7
8
9
10
Install Print Drivers
Be sure to install the necessary print drivers on each computer that
will be accessing the Print Server.
Set Up Print Server
1.
Plug your printer’s USB cable (power on) into the Print Server.
2.
Connect the included Ethernet cable into the Print Server and to
an available Ethernet port on your router or switch.
3. Power up the print server. Allow approximately one minute for
the Print Server to boot.
4. Verify that the Status light is illuminated and that the Error light is
not illuminated.
5.
Determine the Print Server’s IP address, using one of the
following methods:
a) New Print Servers are configured to receive IP addresses
dynamically. If your network has a DHCP server, the Print
Server will obtain an IP address from your network. If the DHCP
server supports a client list, the client list will list the IP address
assigned to the Print Server. If a DHCP server is not available,
after 1.5 minutes the Print Server will revert to 192.168.2.253.
b)
If the Print Server has been configured previously, then it will
have been set to a static IP address that could be different for
every network.
Note:
Restoring factory defaults on the Print Server by
holding in the reset button for 10 seconds while repowering
the Print Server will restore the IP address to dynamic.
c)
Run the program “PSF.exe” from the Installation CD. This will
find the IP address and link automatically to the web-based
management interface.
d)
Go to the last step of the Print Server Installation Wizard, which
has an Advanced button that finds the IP address and links
automatically to the web-based management interface.
6.
Verify that the computer is in the same subnet as the Print Server