Belkin P74393UK - Manual (Page 18)

15 15
se
ct
io
n
2
1
3
4
5
6
7
8
9
10
Accessing the Web Configuration Menus
1.
Connect the included Ethernet cable into the Print Server and to
an available Ethernet port on your router or switch.
2. Power up the Print Server. Allow approximately one minute for
the Print Server to boot and obtain an IP address.
3.
Determine the Print Server’s IP address, using one of the
following methods:
a) New Print Servers are configured to receive IP addresses
dynamically. If your network has a DHCP server, the Print Server
will obtain an IP address from your network. If the DHCP server
supports a client list, the client list will list the IP address
assigned to the Print Server. If a DHCP server is not available,
after 1.5 minutes the Print Server will revert to 192.168.2.253.
b) If the Print Server has been configured previously, then it will
have been set to a static IP address that could be different for
every network.
Note:
Restoring factory defaults on the Print Server by holding in
the reset button for 10 seconds while repowering the Print Server
will restore the IP address to dynamic.
c)
Run the program “PSF.exe” from the Installation CD. This
will find the IP address and link automatically to the web-based
management interface.
d)
Go to the last step of the Print Server Installation Wizard,
which has an Advanced button that finds the IP address and links
automatically to the web-based management interface.
Web Configuration