Briggs & Stratton 8 - Manual (Page 14)

F. Move drum into load position
NOTE: Before starting the engine, check hydraulic fluid level, engine oil level,
and diesel/gasoline fuel level.
1. Hook up electronics. Connect both the Electronic Machine Controller
(Figure 8) and the Hand-Held Wired Remote Controller (Figure 9).
2. Start the engine using the electric start switch at the Electronic Machine
Controller panel (Figure 10).
IMPORTANT! It is critical to warm the hydraulic fluid to 100°F before
operating the machine. Hydraulic fluid temperature is indicated by a
thermometer in the engine compartment (Figure 9a).
3. Turn the controller on by using the switch at the Electronic Machine
Controller panel (Figure 10).
4. Engage the Engine Throttle. Pull out knob located on the Electronic
Machine Controller panel. Or, turn on the throttle switch (if equipped with
electronic throttle).
5. Push Load Drum button on the
Hand-Held Wired Remote Controller.
The drum will move and automatically
stop when in load position.
(See Section 4).
Figure 8. Connect Electronic
Machine Controller
Figure 9. Connect Hand-Held
Wired Remote Controller
14
Figure 9a. Hydraulic Fluid
Thermometer