Briggs & Stratton 8 - Manual (Page 17)

17
D. Rotate arms manually until the far rearward quad block is in a horizontal
position (Figure 14).
E. Open rear fairlead assembly (Figure
15) and lay cable in place (Figure 16).
Important! Cable is loaded from the
back of the trailer to the front using
additional cable from the cable reel,
NOT from the cable slack pulled out in
step B.
F. Open the quad keeper roller by lifting
the roller and pin from its seat
(Figure 17) and lay cable in place.
G. Close and lock the quad keeper roller
(Figure 18).
Figure 14. Position First Quad
Block Horizontally
Figure 15. Open Rear Fairlead
Assembly
Figure 17. LIft Roller And Pin
From Seat And Place Cable
Figure 18. Close and Lock Quad
Keeper Roller
Figure 16. Lay Cable In Place