Sharp LC-90LE757K - Manual (Page 72)

70
Using the 3D glasses
Before using the 3D Glasses
Before using the 3D glasses for the first time,
remove the insulating sheet attached to them.
Attaching the Nose Pad
Attach either of the supplied nose pads as needed
(such as when the glasses do not fit properly). The
glasses come with a large and small nose pad.
Removing the nose pad Attaching the nose pad
Using the 3D glasses
Pairing the 3D glasses
To view 3D images, it is necessary to pair the 3D
glasses and TV.
• To confirm pairing of the 3D glasses and TV, make sure
that 3D images are displayed on the TV screen.
• When the power button is pressed for 2 or more
seconds with the power off, pairing with the TV starts.
When pairing is completed successfully, the LED blinks
in green for 3 seconds.
• To switch between 2D and 3D modes, briefly press the
power button.
50 cm–2 m
NOTE
• When paired, make sure that the 3D glasses are kept
at a distance of 50 cm–2 m from the TV. If too close,
pairing cannot be performed.
Switching to 3D and 2D Mode
When viewing 3D images, you can press the power
button to switch between 2D and 3D modes. This is
useful when several people are viewing 3D images
on the same TV with some people wanting to watch
in 3D and some people wanting to watch in 2D.
E Viewing 2D images
When you press and hold for less than 2
seconds while viewing 3D images, the LED light
blinks in red and the 3D images switch to 2D
images.
E Viewing 3D images
When you press and hold for less than 2
seconds while viewing 2D images, the LED light
blinks in green and the 2D images switch to 3D
images.
Usage Range of the 3D Glasses
The 3D glasses can be used by receiving a signal
sent from the TV.
The 3D glasses turn off automatically after 15
seconds if no signal is received from the TV.
E Operating range
From directly the TV: approx. 5 m (within approx. 30°
horizontally and 20° vertically)
Enjoying 3D image viewing