Sharp UP-3500 - Manual (Page 37)

36
3
IRC Programming
To start IRC programming, first, turn on the machines in the IRC system and put them in the PGM2 mode.
The programming procedures for both the master and satellites will be explained below.
For the setup of your IRC system, please be sure to consult your authorized SHARP dealer.
It is necessary to assign machine numbers to the master and satellites before programming.
1.
Enter the PGM2 mode from the mode selection window.
2.
Select “2 SETTING” from the displayed menu.
The SETTING window will appear.
3.
Select “8 TERMINAL” from the displayed menu.
The TERMINAL window will appear.
4.
Touch the “MACHINE#” line from the displayed items.
Enter a desired number for the machine, and touch the [Exit] key.
Machine number: up to 6 digits (0–999999)
The DATA NOT SAVED SAVE IT? dialogue will appear.
5.
Select “1.SAVE.”
6.
Repeat steps 1 to 5 for all machines in the IRC system.
• In an IRC network, each machine number must be unique. Do not use the same number for
two or more machines.
• Be sure to set up satellites first to allow the downloading of inline preset from the master to
satellites.
NOTE
1. Setting the machine numbers – master and satellite