Burley Honey Bee - Manual (Page 5)

PHOTO 2: Trailer left rear corner
Mounting Reflectors
1. Screw reflectors and brackets together.
2. Loosen screws on reflector brackets. Mount reflectors/
brackets horizontally on rear corners of side frame tubes,
with reflectors extending out past trailer sides.
3. Tighten screws securely. PHOTO 2
Installing Wheel Guards
1. Match holes in wheel guards with holes on outside of lower
side frame tubes.
2. From inside the frame, insert wheel guard screws through
frame tube and wheel guards. Tighten securely. FIGURE 3
Attaching Wheels
1. Insert wheel axle assembly completely into trailer
axle. FIGURE 4
2. Close quick release lever, with lever aimed at trailer rear.
A properly adjusted quick release lever should leave an
imprint on your palm when the lever is rotated to the closed
position.
FIGURE 5
3. Verify that tires are inflated to pressure marked on tire
side wall.
4. To remove wheel from trailer axle, open quick release lever.
Top View
FIGURE 3: Wheel guard installation
FIGURE 4: Quick release lever in unlocked
“open” position
FIGURE 5: Quick release lever in locked
“closed” position
Top View
Trailer
Rear
B U R L E Y H O N E Y B E E O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N U A L 5
MAKE SURE WHEELS ARE HELD SECURELY, WITH WHEEL AXLE
ASSEMBLY FULLY INSERTED INTO TRAILER AXLE. YOU SHOULD
NOT BE ABLE TO ROCK OR SHIFT WHEELS. IMPROPERLY
INSTALLED WHEELS CAN FALL OFF, CAUSING AN ACCIDENT OR
SERIOUS INJURY.
WARNING
MAKE SURE REFLECTORS FACE OUTWARD. INCORRECTLY
INSTALLED REFLECTORS CAN REDUCE VISIBILITY AND CAUSE AN
ACCIDENT OR SERIOUS INJURY.
WARNING
Reflector
Bracket
Left Side
Frame Tube
Lower Side
Frame Tube
Wheel Guard
Screws