Burley Honey Bee - Manual (Page 8)

Using Seat Harness
One Passenger:
Note: In two-passenger trailers, use inner shoulder straps and
middle crotch strap.
1. Place child in center of seat.
2. Snap shoulder straps into Y-buckle, with buckle positioned
at child’s sternum. Adjust straps so that child cannot move
too far forward in seat.
3. Fasten and adjust lap belt snugly. FIGURE 8
Two passengers:
Note: For two children, use both shoulder harnesses and two
outer crotch straps.
1. Seat first child on one side of seat.
2. Snap shoulder straps into Y-buckle, with buckle positioned
at child’s sternum. Adjust straps so that child cannot move
too far forward in seat.
3. Repeat for second child.
4. Fasten and adjust lap belt snugly. To remove children,
release lap belt and harness buckles . FIGURE 9
FIGURE 8
FIGURE 9
8 B U R L E Y H O N E Y B E E O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N U A L
ALWAYS SECURE CHILDREN WITH HARNESS AND LAP BELT
BEFORE USE. ONLY USE THIS SEAT IF YOUR CHILD IS CAPABLE OF
SITTING UPRIGHT ALONE. FAILURE TO DO SO COULD RESULT IN
AN ACCIDENT AND SERIOUS INJURY OR DEATH.
WARNING
IMPORTANT
SINGLE PASSENGER MUST BE SEATED IN CENTER POSITION.
Strap Tubes
Lap Belt
Lap Belt
Strap
Tubes
Outer Crotch
Strap
Outer Crotch
Strap
Strap
Tubes