Warning, Vacuum cleaner won’t run, Vacuum cleaner or tools won’t pick up dirt – Bissell 3593 User Manual
Page 13: Vacuum cleaner is difficult to push, Visible dirt escaping from cleaner
13
Troubleshooting
Vacuum cleaner won’t run
Possible Causes
Remedies
Power cord not plugged in
Check electrical plug
Vacuum cleaner or Tools won’t pick up dirt
Possible Causes
Remedies
Incorrect Height Adjustment
Adjust Powerfoot to correct height setting
Hose not attached to suction opening
Grasp Quick Reach Handle and firmly push Hose
Wand onto the suction opening
Twist ‘n Snap Hose not securely attached
Make sure Twist ‘n Snap Hose is snapped into
locked
position
Crack or hole in Hose
Check Hose and replace if needed
Broken or worn Drive Belt
Replace Drive Belt, see page 11
Rotating Floor Brush bristles worn
Replace brush
Rotating Floor Brush jammed
Remove brush and clean debris from brush ends
Clog in vacuum
Clear clog, see page 12
Dirt Container full
Empty Dirt Container
Dirt Container or Upper Tank not installed properly
Position correctly and lock in place
Filters are dirty
Check and clean Upper Tank,
Pre-Motor and Post-Motor Filters
Vacuum cleaner is difficult to push
Possible Causes
Remedies
Incorrect Height Adjustment
Adjust Powerfoot to correct height setting
Visible dirt escaping from cleaner
Possible Causes
Remedies
Dirt Container full
Empty Dirt Container
Filters missing or installed incorrectly
Check Upper Tank, Pre-Motor and Post-Motor
Filters for correct installation
Dirt Container installed incorrectly
Pull out and re-insert Dirt Container correctly
If suggested solutions for this or any function of the CleanView Bagless Power Trak Plus
do not correct the problem, call BISSELL Consumer Services.
1
1
1
1
2
2
3
3
9
9
7
8
8
4
4
5
5
6
6
10
10
WARNING:
To reduce the risk of injury from
moving parts and/ or electrical
shock, turn Power Switch OFF
and disconnect plug from electrical
outlet before performing
troubleshooting checks.
11
11
7
1
1
2
2
3
3
1
1