Philips SENSEO® Quadrante Cafetera de monodosis de café - Manual (Page 7)

7
• The boiler fills itself with water from the
water reservoir. This takes some time
(approx. 90 to 150 seconds). During
the flushing cycle, the machine produces
more noise than during a regular brewing
cycle.
D Note:
Before you use the machine for the first time,
clean the coffee spout, the cover of the coffee
spout, the coffee collector, the pod holders
and the water reservoir in the dishwasher or
with hot water and some washing-up liquid.
Now your Philips SENSEO ® coffee machine is
ready for use.
5 Using the machine
B Warning:
If you only get a small quantity of coffee or no
coffee at all out of the machine, you have not
flushed the machine properly before first use. As
a result, the boiler is not or only partly filled. Flush
the machine properly (see chapter ‘Preparing the
machine for use’) before you brew another cup
of coffee.
1
Fill the water reservoir with cold water up to
the MAX indication and put it back into the
machine. (Fig. 3)
B Warning:
Never pour milk, coffee, hot water or
carbonated water into the water reservoir.
• q MIN: minimum amount of water
required to brew 1 cup of SENSEO ®
coffee.
• qq MIN: minimum amount of water
required to brew 2 cups of SENSEO ®
coffee.
• A full reservoir allows you to make
SENSEO ® coffee a number of times (up
to 8 cups). This makes it unnecessary to fill
the water reservoir each time you want
to make a cup of coffee.
4 Preparing the
machine for use
B Warning:
You cannot brew coffee if you have not flushed
the SENSEO ® coffee machine first!
The flushing cycle causes the boiler to fill with
water. After this, the coffee machine is ready for
use.
Flush the machine in the following way:
1
Tilt the water reservoir outwards and lift it
out of the machine (Fig. 2).
2
Fill the water reservoir with cold water up to
the MAX indication. (Fig. 3)
3
To put the water reservoir back into the
machine, tilt it slightly and insert the bottom
of the water reservoir first (1). Then press
home the top part of the water reservoir (2).
4
Move the lid release lever upwards and open
the lid (Fig. 4).
5
Put the 1-cup pod holder q or the 2-cup pod
holder qq in the machine without pod or
pods. (Fig. 5)
6
Close the lid and lock the lever (Fig. 6).
B Warning:
Make sure the lid is closed properly and the
lid lever is locked before you start flushing the
machine.
7
Put the plug in an earthed wall socket.
8
Put a bowl (with a capacity of at least
1500ml) under the coffee spout to collect the
water. (Fig. 7)
D Note:
Make sure the bowl is placed stably on the
drip tray or the foot of the machine to
prevent it from wobbling or toppling over
during the flushing cycle. You can also use a
square or rectangular container.
9
Press the on/off button 3 (1) and then press
the 1-cup button q and the 2-cup button
qq briefly at the same time (2). (Fig. 8)
ENGLISH