Bosch WTMC5521 - Manual (Page 10)

10
Check list before using
the dryer
1. Check that steps 1-12 have been
implemented properly.
2. Ensure that the dryer is connected
to the power supply.
3. Open the shutoffĆvalve.
4. Read the operating instructions to
understand how your dryer
operates.
5. Conduct an appliance test:
q Check that the drum is empty.
q Close the dryer door.
q Switch the dryer to Extra Dry"
and then press the Start
button.
q After 3-5 minutes press the
Stop button and open the door.
6. If the interior of the dryer feels
warm, the dryer has been
connected properly.
Switch the dryer to Off".
7. If the dryer does not work, switch
the dryer to Off".
Look in the troubleshooting
section (page 20) of the
OPERATING INSTRUCTIONS and
find the fault.
Preparing to transport the
dryer ć step by step
1. Close the shutĆoff valve.
2. Rotate the program selector to
Off".
3. Pull out the power supply plug
or
turn off the circuit breaker.
4. Disconnect gas supply
5. Disconnect the exhaust duct from
the exhaust air outlet on the dryer.
6. Place any accessories in the drum.
7. Close the door and secure with
adhesive tape.
8. Screw the heightĆadjustable feet of
the dryer into the housing to
prevent them from being damaged
during transportation.