Bosch WTMC5521 - Manual (Page 4)

4
5. Do not reach into the appliance if
the drum is rotating.
6. Do not install or store this
appliance where it will be exposed
to the weather.
7. Do not tamper with the controls.
8. Do not repair or replace any part of
the appliance or attempt any
service unless specifically
recommended in the
userĆmaintenance instructions or
in published user repair
instructions that you understand
and have the skills to carry out.
9. Do not use fabric softeners or
products to eliminate static unless
recommended by the fabric
manufacturer.
10. Do not use heat to dry articles
containing foam rubber or similarly
textured rubberĆlike materials.
Foam rubber materials can ignite
when heated.
11. Clean lint screen before or after
each load.
12. Keep area around the exhaust
opening and adjacent surrounding
areas free from the accumulation
of lint, dust and dirt. An obstructed
port might reduce the airflow and
cause over heating.
13. The interior of the machine and
exhaust duct should be cleaned
periodically by qualified service
personnel.
14. Removing any panel or cover,
including the light cover, may
expose live electrical circuits.
Always unplug the dryer from the
electrical supply before attempting
any service.
15. Store all laundry chemicals and
aids in a cool dry place according
to the manufacturer's instructions.
Make sure children cannot reach
them.
16. To reduce the risk of fire, clothes,
cleaning rags, mop heads and the
like which have traces of any
flammable substance, such as
vegetable oil, cooking oil,
petroleum based oils or distillates,
waxes, fats, etc., must not be
placed in the dryer. These items
may contain some flammable
substance(s) even after washing.
17. Combustible materials, gasoline,
and other flammable vapors and
liquids must not be stored near the
dryer.
18. Do not place items exposed to
cooking oils in your dryer. Items
contaminated with cooking oils
may contribute to a chemical
reaction that could cause a load to
catch fire.
19. Do not climb or sit on top of
the dryer.
20. To reduce the risk of fire or
electrical shock, DO NOT use an
extension cord or an adapter to
connect the dryer to the electrical
power supply.
21. The dryer must only be used for its
intended purpose.
22. Always check pockets and remove
any objects. Cigarette lighters are
particularly hazardous.
23. Do not operate until worn out
power cords and/or loose plugs
are replaced.
24. Do not operate the dryer if any
guards and/or panels have been
removed.
25. Do not operate the dryer if any
parts are missing or broken.
26. Do not bypass any safety devices.
27. Do not use a plastic or nonĆmetal
flexible duct with this dryer. Plastic
or nonĆmetal flexible duct are a
potential fire hazard.
28. Do not operate this dryer until you
are sure that the dryer has been
installed according to the
INSTALLATION INSTRUCTIONS
and that installation and grounding
are in compliance with all local
regulations and/or other applicable
regulations and requirements.
29. Failure to install, maintain and/or
operate the dryer according to
the manufacĆ turer's instructions
may result in injury and/or
damage.
30. BEFORE THE APPLIANCE IS
REMOVED FROM SERVICE OR
DISCARDED, REMOVE THE
DOOR TO THE DRYING
COMPARTMENT.
31. To avoid floor damage and mold
growth, do not let spills or
splashout cause standing water
around or under the appliance.
32. No other fuelĆburning appliances
shall be installed in the same
closet as the dryer.
33. Removing any panel, including
the round service panel in the
front can expose sharp edges
and points, electrical
connections and hot surfaces.
Notes:
A The IMPORTANT
SAFEGUARDS and
WARNINGS presented in this
manual do not cover all
possible conditions that may
occur.
Common sense, caution and
care must be exercised when
installing, maintaining or
operating the dryer.
B Always contact your dealer,
distributor, service agent or
the manufacturer about any
problems or conditions that
you do not understand.
C Follow also the Safety
Information in the
INSTALLATION
INSTRUCTIONS and the
OPERATING
INSTRUCTIONS.
GROUNDING
INSTRUCTIONS
This appliance must be grounded. In
the event of malfunction or breakdown,
grounding will reduce the risk of electric
shock by providing a path of least
resistance for the electric current. This
appliance is equipped with a cord
having an equipmentĆgrounding
conductor and a grounding plug. The
plug must be plugged into an
appropriate outlet that is properly
installed and grounded in accordance
with all local codes and ordinances.
For the State of Massachusetts InĆ
stallations:
1. Installation must be performed by
a licensed plumber or gas fitter liĆ
censed by the state, province or reĆ
gion where this appliance is being
installed.
2. Shut-off valve must be a T" handĆ
le gas cock.
3. Flexible gas connector must not be
longer than 36 inches.