BenQ H200:A - Manual (Page 21)

User’s manual
Operation 19
OPERATION
Before using the TV set, please check your TV system first and adjust TV set to comply with the TV broadcasting
system in your territory. (There will be slightly different selection items in different TV systems)
Note:
The 3 Dimensional Y/C separation circuit only works when the color system is set to NTSC 60Hz / 3.58 MHz in
TV mode and Video mode.
The 3 Dimensional Y/C separation circuit is used to remove flickering and color bleeding.
Basic Operation
Turning On/Off and Standby
POWER
POWER
1. Connecting the power plug of LCD TV to the Wall Outlet. (When you do so, the
main power turns ON and enters into standby mode. (Power Indicator: no light)
2. Press “POWER “button, located on the front control panel of the main unit or
on the Remote Control, to turn on the TV.
3. The BenQ logo appears on screen (Power Indicator: Blue)
4. The display will automatically search last selected signal input and display it if it
connects to any source.
To turn off the LCD TV
5. Press
“POWER” button again to enter standby mode (Power Indicator: no light
(standby)).
Switching TV/VIDEO/PC [PC/AV/Y Pb Pr/Y Cb Cr/TV] Modes
INPUT
INPUT
1. Turn on the power of the connected video equipment or PC.
2. Press “INPUT” button on the front control panel of the main unit or on the
Remote Control to display the input selected menu.
3. Press “INPUT” button directly to select input source you want or you can also
press or to select the applicable input source.