Baldor PC32RI - Manual (Page 13)

Section 3
Receiving & Installation
Receiving & Installation 3-1 MN2403
Receiving & Inspection When you receive your generator, there are several things you should do immediately.
1. Observe the condition of the shipping container and report any damage immediately to
the commercial carrier that delivered your system.
2. Verify that the part number of the system you received is the same as the part number
listed on your purchase order.
3. If the system is to be stored for several weeks before use, be sure that it is stored in a
location that conforms to published storage temperature and humidity specifications.
Lifting the Generator
The generator weighs about 75 lbs dry. Use proper lift equipment and methods to avoid injury.
Figure 3-1 PC32Ri/43Ri Portable Generator Control Panel
STOP
RUN
CHOKE
+ −
− +
Engine
Switch
Auto Power
Save Display
Display
Oil Level
Lamp
Units LED’s
Key
Switch
Units
Select
Switch
Auto Power Save Switch
NEMA 5−20R NEMA L530R
Ground
Terminal
Battery Charger
Connections
DC
Breaker STOP
ON
START
BATTERY CHARGE ONLY
DC 12V − 8.3A
~ AC OUTPUT
Storage If you will not be using the generator set for a significant amount of time (3 months or longer) you
should store the generator to prevent any problems that could arise from sitting idle. Please fully
read the storage guidelines in Section 5 of this manual.
WARNING: Never store an engine with fuel in its tank indoors or in an enclosed, poorly ventilated area
where gasoline fumes could reach an ignition source and cause an explosion.