Baldor PC32RI - Manual (Page 24)

5-2 Troubleshooting and Maintenance MN2403
Clean/Adjust Spark Plug (Left side cover)
1. Remove the plug wire and spark plug.
2. .If the spark plug is contaminated, remove the carbon buildup with a plug cleaner or wire brush.
3. Adjust the electrode gap to 0.025 in. (0.6mm).
4. Install the spark plug and plug wire. 0.024 − 0.028 in.
(0.6 − 0.7 mm) NGKBR−6HS
or RL86C
Clean Spark Arrester
1. Remove the flange bolts from the muffler cover and remove the muffler cover.
2. Remove the screw that secures the spark arrester and remove the spark arrestor from the muffler.
3. Clean and remove carbon deposits from spark arrester with a wire brush. Be careful not to damage the
fine mesh screen material. Replace spark arrester if damaged (breaks or holes).
4. Install spark arrester in muffler and secure with screw.
5. Install muffler cover and secure with flange bolts.
Cleaning Keeping the generator clean is an important part of good operation. If dirt buildup is not
removed, the generator will run hotter than normal and it’s life is reduced. The following are
general guidelines for cleaning.
1. Clean the generator set and remove any and all dust, dirt, or other foreign material.
2. Inspect and clean the cooling air intake and exhaust louvers of the generator end.
Make sure they are clean. Remove dirt or any buildup that may restrict the cooling air
flow.
3. Clean the generator set and its components with a damp cloth or sponge.
Never use a water hose or pressure washer as this may damage electrical
components.
4. Inspect and replace any control panel components that are broken or not working
properly (receptacles, circuit breakers, switches, etc.)
5. Inspect and clean all governor and carburetor linkages so they operate properly.
Table 5-1 Periodic Maintenance Schedule
Maintenance Item 8 Hours or
Daily
50 Hours or
Weekly
100 Hours 200 Hours or
Monthly
500 Hours 1000 Hours
Check condition of AC Receptacles and GFCI operation
S
Check condition of Extension Cords
S
Check condition of DC terminals
S
Check condition of Engine Switch
S
Clean generator and check tightness of bolts and nuts.
S
Check engine oil level and replenish (to upper level) if
necessary.
S
Change engine oil (see Note 1)
S
Clean Spark Plug and set plug air gap
S
Replace Spark Plug
S
Clean Air Filter element
S
Replace Air Filter element
S
Replace Fuel Filter
S
Replace Spark Arrestor
S
Remove carbon from Cylinder Head (see Note 2)
S
Check and adjust Valve Clearance (see Note 2)
S
Clean and adjust carburetor (see Note 2)
S
Clean and replace Carbon Brushes
S
Replace Fuel Lines (annually)
S
Check condition of Rotor
S
Check condition of Stator
S
Replace Engine Mounts
S
Note 1: Initial oil change should be performed after 20 hours of operation and every 100 hours
thereafter. Dispose of used oil properly at recycling center.
Note 2: Please consult with Baldor Service for the correct procedures to follow for these items.